[PATCH] MTD/GPMI : select more modules for GPMI by default
Huang Shijie
b32955 at freescale.com
Sat Dec 31 00:48:00 EST 2011
于 2011年12月31日 13:44, Shawn Guo 写道:
> On Fri, Dec 30, 2011 at 12:45:37PM +0800, Huang Shijie wrote:
>> The gpmi-nand driver needs the mxs-dma driver. So select the
>> MXS_DMA by default. So does the MTD_CHAR.
>>
>> Signed-off-by: Huang Shijie<b32955 at freescale.com>
>> ---
>> drivers/mtd/nand/Kconfig | 2 ++
>> 1 files changed, 2 insertions(+), 0 deletions(-)
>>
>> diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
>> index 07c4774..1b14a3a 100644
>> --- a/drivers/mtd/nand/Kconfig
>> +++ b/drivers/mtd/nand/Kconfig
>> @@ -420,6 +420,8 @@ config MTD_NAND_NANDSIM
>> config MTD_NAND_GPMI_NAND
>> bool "GPMI NAND Flash Controller driver"
>> depends on MTD_NAND&& (SOC_IMX23 || SOC_IMX28)
>> + select MXS_DMA
> We should probably have it depend on MXS_DMA rather than select it.
IMHO, I think `select` is better. :)
The MXS_DMA not only service for NAND, but SD card, etc.
In logic, the GPMI does not depends on MXS_DMA, the GPMI may use SDMA
too(just in logically).
Best Regards
Huang Shijie
> Regards,
> Shawn
>
>> + select MTD_CHAR
>> select MTD_PARTITIONS
>> select MTD_CMDLINE_PARTS
>> help
>> --
>> 1.7.0.4
More information about the linux-arm-kernel
mailing list