[PATCH] S3C: enable debuging over UART3
Gusakov Andrey
dron0gus at gmail.com
Thu Dec 29 08:07:15 EST 2011
From: Gusakov Andrey <dron_gus at mail.ru>
Some S3C24XX SoCs have 4 uarts. This patch allow set uart3 for
debug output.
Signed-off-by: Gusakov Andrey <dron0gus at gmail.com>
---
arch/arm/Kconfig.debug | 11 +++++++++++
arch/arm/plat-samsung/Kconfig | 1 +
2 files changed, 12 insertions(+), 0 deletions(-)
diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
index c5213e7..0b3debd 100644
--- a/arch/arm/Kconfig.debug
+++ b/arch/arm/Kconfig.debug
@@ -231,6 +231,17 @@ choice
The uncompressor code port configuration is now handled
by CONFIG_S3C_LOWLEVEL_UART_PORT.
+ config DEBUG_S3C_UART3
+ depends on PLAT_SAMSUNG
+ bool "Use S3C UART 3 for low-level debug"
+ help
+ Say Y here if you want the debug print routines to direct
+ their output to UART 3. The port must have been initialised
+ by the boot-loader before use.
+
+ The uncompressor code port configuration is now handled
+ by CONFIG_S3C_LOWLEVEL_UART_PORT.
+
config DEBUG_REALVIEW_STD_PORT
bool "RealView Default UART"
depends on ARCH_REALVIEW
diff --git a/arch/arm/plat-samsung/Kconfig b/arch/arm/plat-samsung/Kconfig
index 313eb26..7ead783 100644
--- a/arch/arm/plat-samsung/Kconfig
+++ b/arch/arm/plat-samsung/Kconfig
@@ -344,5 +344,6 @@ config DEBUG_S3C_UART
default "0" if DEBUG_S3C_UART0
default "1" if DEBUG_S3C_UART1
default "2" if DEBUG_S3C_UART2
+ default "3" if DEBUG_S3C_UART3
endif
--
1.7.0.4
More information about the linux-arm-kernel
mailing list