[PATCH v2 1/7 v2] ARM: OMAP1: ams-delta: register latch dependent devices later
Janusz Krzysztofik
jkrzyszt at tis.icnet.pl
Thu Dec 22 05:39:15 EST 2011
On Wednesday 21 of December 2011 at 21:07:29, Tony Lindgren wrote:
> * Janusz Krzysztofik <jkrzyszt at tis.icnet.pl> [111221 11:20]:
> > On Wednesday 21 of December 2011 at 20:08:15, Tony Lindgren wrote:
> > > * Janusz Krzysztofik <jkrzyszt at tis.icnet.pl> [111220 13:23]:
> > > > In preparation to converting Amstrad Delta on-board latches to
> > > > basic_mmio_gpio devices, registration of platform devices which depend
> > > > on latches and will require initialization of their GPIO pins first,
> > > > should be moved out of .machine_init down to late_initcall level, as the
> > > > gpio-generic driver is not available until device_initcall time. The
> > > > latch reset operation, which will be replaced with GPIO initialization,
> > > > must also be moved to late_initcall for the same reason.
> > > >
> > > > Since there was already another, separate arch_initcall function for
> > > > setting up one of those latch dependent devices, the on-board modem
> > > > device, reuse that function, i.e., rename it to a name that matches the
> > > > new purpose, extend with other device setup relocated from
> > > > .machine_init, and move down to the late_initcall level.
> > > >
> > > > While being at it, add missing gpio_free() in case the modem platform
> > > > device registration fails.
> > > >
> > > > Thanks to Tony Lindgren <tony at atomide.com> who suggested this approach
> > > > instead of shifting up the gpio-generic driver initialization.
> > > >
> > > > In addition, defer registration of the Amstrad Delta ASoC and serio
> > > > devices, done from their device driver files, until late_initcall time,
> > > > as those drivers will depend on their GPIO pins already requested from
> > > > the board late_init() function until updated to register their GPIO pins
> > > > themselves.
> > > >
> > > > Created and tested against linux-3.2-rc6.
> > > >
> > > > Signed-off-by: Janusz Krzysztofik <jkrzyszt at tis.icnet.pl>
> > >
> > > Planning to apply this series. Dmitry, care to ack the drivers/input/serio/
> > > related change?
> >
> > Don't we need Jarkko's or Mark's or Liam's ack as well for the change to
> > the sound/soc/omap/ams-delta.c file?
>
> Yes, you're right.
Jarkko, Mark or Liam, care to ack this change, moving the Amstrad Delta
sound card registration to late_initcall?
Thanks,
Janusz
> > > > Changes since the initial version of this patch:
> > > > * use late_initcall() unconditionally in modules, requested by Russell
> > > > King (thanks!); an updated patch 7/7 will follow,
> > > > * in the changelog message, move credits to Tony up a bit, since the
> > > > person responsible for other changes (he might not necessarily like)
> > > > is me, not him ;).
> > > >
> > > > Comments copied from this patch initial submission:
> > > > This patch was not present in the initial submission, it replaces the
> > > > old patch 1/10, providing an alternative solution not touching the
> > > > gpio-generic driver.
> > > >
> > > > arch/arm/mach-omap1/board-ams-delta.c | 28 ++++++++++++++++++++--------
> > > > drivers/input/serio/ams_delta_serio.c | 2 +-
> > > > sound/soc/omap/ams-delta.c | 2 +-
> > > > 3 files changed, 22 insertions(+), 10 deletions(-)
> > > >
> > > > diff --git a/arch/arm/mach-omap1/board-ams-delta.c b/arch/arm/mach-omap1/board-ams-delta.c
> > > > index b0f15d2..50987c9 100644
> > > > --- a/arch/arm/mach-omap1/board-ams-delta.c
> > > > +++ b/arch/arm/mach-omap1/board-ams-delta.c
> > > > @@ -275,11 +275,14 @@ static struct omap1_cam_platform_data ams_delta_camera_platform_data = {
> > > > };
> > > >
> > > > static struct platform_device *ams_delta_devices[] __initdata = {
> > > > - &ams_delta_nand_device,
> > > > &ams_delta_kp_device,
> > > > + &ams_delta_camera_device,
> > > > +};
> > > > +
> > > > +static struct platform_device *late_devices[] __initdata = {
> > > > + &ams_delta_nand_device,
> > > > &ams_delta_lcd_device,
> > > > &ams_delta_led_device,
> > > > - &ams_delta_camera_device,
> > > > };
> > > >
> > > > static void __init ams_delta_init(void)
> > > > @@ -307,9 +310,6 @@ static void __init ams_delta_init(void)
> > > > omap_serial_init();
> > > > omap_register_i2c_bus(1, 100, NULL, 0);
> > > >
> > > > - /* Clear latch2 (NAND, LCD, modem enable) */
> > > > - ams_delta_latch2_write(~0, 0);
> > > > -
> > > > omap1_usb_init(&ams_delta_usb_config);
> > > > omap1_set_camera_info(&ams_delta_camera_platform_data);
> > > > #ifdef CONFIG_LEDS_TRIGGERS
> > > > @@ -345,13 +345,18 @@ static struct platform_device ams_delta_modem_device = {
> > > > },
> > > > };
> > > >
> > > > -static int __init ams_delta_modem_init(void)
> > > > +static int __init late_init(void)
> > > > {
> > > > int err;
> > > >
> > > > if (!machine_is_ams_delta())
> > > > return -ENODEV;
> > > >
> > > > + /* Clear latch2 (NAND, LCD, modem enable) */
> > > > + ams_delta_latch2_write(~0, 0);
> > > > +
> > > > + platform_add_devices(late_devices, ARRAY_SIZE(late_devices));
> > > > +
> > > > omap_cfg_reg(M14_1510_GPIO2);
> > > > ams_delta_modem_ports[0].irq =
> > > > gpio_to_irq(AMS_DELTA_GPIO_PIN_MODEM_IRQ);
> > > > @@ -367,9 +372,16 @@ static int __init ams_delta_modem_init(void)
> > > > AMS_DELTA_LATCH2_MODEM_NRESET | AMS_DELTA_LATCH2_MODEM_CODEC,
> > > > AMS_DELTA_LATCH2_MODEM_NRESET | AMS_DELTA_LATCH2_MODEM_CODEC);
> > > >
> > > > - return platform_device_register(&ams_delta_modem_device);
> > > > + err = platform_device_register(&ams_delta_modem_device);
> > > > + if (err)
> > > > + goto gpio_free;
> > > > + return 0;
> > > > +
> > > > +gpio_free:
> > > > + gpio_free(AMS_DELTA_GPIO_PIN_MODEM_IRQ);
> > > > + return err;
> > > > }
> > > > -arch_initcall(ams_delta_modem_init);
> > > > +late_initcall(late_init);
> > > >
> > > > static void __init ams_delta_map_io(void)
> > > > {
> > > > diff --git a/drivers/input/serio/ams_delta_serio.c b/drivers/input/serio/ams_delta_serio.c
> > > > index d4d08bd..835d37a 100644
> > > > --- a/drivers/input/serio/ams_delta_serio.c
> > > > +++ b/drivers/input/serio/ams_delta_serio.c
> > > > @@ -165,7 +165,7 @@ serio:
> > > > kfree(ams_delta_serio);
> > > > return err;
> > > > }
> > > > -module_init(ams_delta_serio_init);
> > > > +late_initcall(ams_delta_serio_init);
> > > >
> > > > static void __exit ams_delta_serio_exit(void)
> > > > {
> > > > diff --git a/sound/soc/omap/ams-delta.c b/sound/soc/omap/ams-delta.c
> > > > index ccb8a6a..be81bc7 100644
> > > > --- a/sound/soc/omap/ams-delta.c
> > > > +++ b/sound/soc/omap/ams-delta.c
> > > > @@ -636,7 +636,7 @@ err:
> > > > platform_device_put(ams_delta_audio_platform_device);
> > > > return ret;
> > > > }
> > > > -module_init(ams_delta_module_init);
> > > > +late_initcall(ams_delta_module_init);
> > > >
> > > > static void __exit ams_delta_module_exit(void)
> > > > {
> > >
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majordomo at vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
>
More information about the linux-arm-kernel
mailing list