[PATCH v3 02/11] i2c: OMAP: Add DT support for i2c controller

Cousson, Benoit b-cousson at ti.com
Thu Dec 22 03:55:39 EST 2011


Hi Rob,

On 12/20/2011 5:42 PM, Rob Herring wrote:
> On 12/20/2011 10:27 AM, Benoit Cousson wrote:
>> Add initial DT support to retrieve the frequency using a
>> DT attribute instead of the pdata pointer if of_node exist.
>>
>> Add documentation for omap i2c controller binding.
>>
>> Based on original patches from Manju and Grant.
>>
>> Signed-off-by: Benoit Cousson<b-cousson at ti.com>
>> Cc: Ben Dooks<ben-linux at fluff.org>
>> Cc: Kevin Hilman<khilman at ti.com>
>
> One issue below, otherwise:
>
> Reviewed-by: Rob Herring<rob.herring at calxeda.com>
>
>
>> @@ -1001,15 +1019,24 @@ omap_i2c_probe(struct platform_device *pdev)
>>   		goto err_release_region;
>>   	}
>>
>> -	if (pdata != NULL) {
>> -		speed = pdata->clkrate;
>> +	match = of_match_device(omap_i2c_of_match,&pdev->dev);
>> +	if (match) {
>> +		u32 freq = 100000; /* default to 100000 Hz */
>> +
>> +		pdata = match->data;
>> +		dev->dtrev = pdata->rev;
>> +		dev->flags = pdata->flags;
>> +
>> +		of_property_read_u32(node, "clock-frequency",&freq);
>> +		/* convert DT freq value in Hz into kHz for speed */
>> +		dev->speed = freq / 1000;
>> +	} else if (pdata != NULL) {
>> +		dev->speed = pdata->clkrate;
>> +		dev->flags = pdata->flags;
>>   		dev->set_mpu_wkup_lat = pdata->set_mpu_wkup_lat;
>> -	} else {
>> -		speed = 100;	/* Default speed */
>> -		dev->set_mpu_wkup_lat = NULL;
>> +		dev->dtrev = pdata->rev;
>
> If you get here, pdata is NULL.

Mmm, it should not. It's true that the patch is not super readable, but 
here is the result:

	if (match) {
		u32 freq = 100000; /* default to 100000 Hz */

		pdata = match->data;
		dev->dtrev = pdata->rev;
		dev->flags = pdata->flags;

		of_property_read_u32(node, "clock-frequency", &freq);
		/* convert DT freq value in Hz into kHz for speed */
		dev->speed = freq / 1000;
	} else if (pdata != NULL) {
		dev->speed = pdata->clkrate;
		dev->flags = pdata->flags;
		dev->set_mpu_wkup_lat = pdata->set_mpu_wkup_lat;
		dev->dtrev = pdata->rev;
	}

I removed every other pdata reference after this point.

Regards,
Benoit



More information about the linux-arm-kernel mailing list