[PATCH] davinci: DA850 EVM: OHCI platform code

[Manjunathappa, Prakash]

Hi Sergei,

On Tue, Dec 20, 2011 at 16:47:22, Sergei Shtylyov wrote:
> Hello.
> 
> On 20-12-2011 10:36, Manjunathappa, Prakash wrote:
> 
> > From: Ajay Kumar Gupta<ajay.gupta at ti.com>
> 
> > On this board the OHCI port's power control and over-current signals from
> > TPS2065 power switch are connected via GPIO1[15] and GPIO2[1] respectively,
> > so we can implement the DA8xx OHCI glue layer's hooks for overriding the
> > root hub port's power and over-current status bits.
> 
> > We also have to properly set up the clocking mode in the CFGCHIP2 register,
> > so that internal 24 MHz reference clock is fed to the USB 2.0 (MUSB) PHY and
> > its output is used to clock the USB 1.1 (OHCI) PHY...
> 
> > Signed-off-by: Ajay Kumar Gupta <ajay.gupta at ti.com>
> 
>     BTW, Prakash, as you'r on the patch's disrtibution path, shouldn't you add 
> your signoff as well?
> 

Yes, I will make it point to keep my signoff as well while distributing.

> > ---
> >   arch/arm/mach-davinci/board-da850-evm.c |  126 +++++++++++++++++++++++++++++++
> >   1 files changed, 126 insertions(+), 0 deletions(-)
> 
> > diff --git a/arch/arm/mach-davinci/board-da850-evm.c b/arch/arm/mach-davinci/board-da850-evm.c
> > index 6659a90..df74ba5 100644
> > --- a/arch/arm/mach-davinci/board-da850-evm.c
> > +++ b/arch/arm/mach-davinci/board-da850-evm.c
> [...]
> > +static __init void da850_evm_usb_init(void)
> > +{
> [...]
> > +	ret = gpio_request(ON_BD_USB_DRV, "ON_BD_USB_DRV");
> > +	if (ret) {
> > +		printk(KERN_ERR "%s: failed to request GPIO for USB 1.1 port "
> > +		       "power control: %d\n", __func__, ret);
> > +		return;
> > +	}
> > +	gpio_direction_output(ON_BD_USB_DRV, 0);
> 
>     You should also use gpio_request_one() instead 
> gpio_request()/gpio_direction_output() pair.
> 

Agreed, I will use gpio_request_one().

> > +
> > +	ret = gpio_request(ON_BD_USB_OVC, "ON_BD_USB_OVC");
> > +	if (ret) {
> > +		printk(KERN_ERR "%s: failed to request GPIO for USB 1.1 port "
> > +		       "over-current indicator: %d\n", __func__, ret);
> > +		return;
> > +	}
> > +	gpio_direction_input(ON_BD_USB_OVC);
> 
>     Same here.
> 

Agreed.

Thanks,
Prakash

> WBR, Sergei
>