[PATCH v2 0/5] ARM: OMAP2+: Interrupt controllers adaptation to DT

[Benoit Cousson]

Hi Tony and Rob,

Here is the series to take advantage of the new DT interrupt init mechanism.
Thanks to Marc's CONFIG_MULTI_IRQ_HANDLER series, OMAP4 just has to use the
default GIC binding and does not need some OMAP specific hacks anymore.
OMAP2 and 3 are using a simple interrupt controller that can thus expose
a simpler binding.

This update, compared to v1 [1], is introducing the IRQ domain for the
OMAP2&3 INTC by default for both DT and none-DT build.
Please note that in the near future that code can even be simplier with the
introduction of the domain support inside generic irq chip.

This series is based on lo/dt branch to get the needed cleanup and fixes for
OMAP.

The series is available here for reference:
git://gitorious.org/omap-pm/linux.git for_3.3/2_dt_irq

Regards,
Benoit

[1] http://www.spinics.net/lists/linux-omap/msg61152.html


Benoit Cousson (5):
  arm/dts: OMAP4: Update DTS file with new GIC bindings
  ARM: OMAP2/3: intc: Add irqdomain support
  ARM: OMAP2/3: intc: Add DT support for TI interrupt controller
  arm/dts: OMAP3: Add interrupt-controller bindings for INTC
  ARM: OMAP2+: board-generic: Use of_irq_init API

 .../devicetree/bindings/arm/omap/intc.txt          |   27 +++++++++++
 arch/arm/boot/dts/omap3.dtsi                       |    6 ++-
 arch/arm/boot/dts/omap4.dtsi                       |    3 +-
 arch/arm/mach-omap2/board-generic.c                |   30 +++++++------
 arch/arm/mach-omap2/common.h                       |   10 ++++
 arch/arm/mach-omap2/irq.c                          |   48 ++++++++++++++++++--
 6 files changed, 103 insertions(+), 21 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/arm/omap/intc.txt