[PATCH 3/9] irq: convert generic-chip to use irq_domain
Grant Likely
grant.likely at secretlab.ca
Thu Dec 15 11:39:34 EST 2011
On Thu, Dec 15, 2011 at 9:17 AM, Rob Herring <robherring2 at gmail.com> wrote:
> On 12/15/2011 09:55 AM, Grant Likely wrote:
>> On Thu, Dec 15, 2011 at 6:56 AM, Rob Herring <robherring2 at gmail.com> wrote:
>>> Shawn,
>>>
>>> On 12/15/2011 07:39 AM, Rob Herring wrote:
>>>> On 12/14/2011 11:55 PM, Shawn Guo wrote:
>>>>> On Thu, Dec 15, 2011 at 01:25:20PM +0800, Shawn Guo wrote:
>>>>>> On Wed, Dec 14, 2011 at 09:28:52AM -0600, Rob Herring wrote:
>>>>>>> From: Rob Herring <rob.herring at calxeda.com>
>>>>>>>
>>>>>>> Add irq domain support to irq generic-chip. This enables users of
>>>>>>> generic-chip to support dynamic irq assignment needed for DT interrupt
>>>>>>> binding. Users must be converted to use irq_data.hwirq for determining
>>>>>>> local interrupt numbers rather than using the Linux irq number.
>>>>>>>
>>>>>>> irq_base is kept for now as there are a few users of it. Once they
>>>>>>> are converted to use the irq domain, it can be removed.
>>>>>>>
>>>>>>> Signed-off-by: Rob Herring <rob.herring at calxeda.com>
>>>>>>> Cc: Thomas Gleixner <tglx at linutronix.de>
>>>>>>> ---
>>>>>>
>>>>>> Tested-by: Shawn Guo <shawn.guo at linaro.org>
>>>>>>
>>>>> Sorry, I have to take that tag back after I correct my test setup.
>>>>> It does not work for imx5 TZIC case, because the following change
>>>>> I suggested before is missed.
>>>>>
>>>>> diff --git a/kernel/irq/irqdomain.c b/kernel/irq/irqdomain.c
>>>>> index eb763f7..2a2aac1 100644
>>>>> --- a/kernel/irq/irqdomain.c
>>>>> +++ b/kernel/irq/irqdomain.c
>>>>> @@ -39,7 +39,7 @@ void irq_domain_add(struct irq_domain *domain)
>>>>> return;
>>>>> }
>>>>> d->domain = domain;
>>>>> - d->hwirq = hwirq;
>>>>> + d->hwirq = hwirq - domain->hwirq_base;
>>>>
>>>> This is a problem. It entirely defeats the point of hwirq_base and it
>>>> would break the GIC. We need to fix this in the generic irq chip.
>>>>
>>>
>>> I think I found a fix. Can you try 's/d->hwirq/(d->hwirq % 32)/' in
>>> generic-chip.c.
>>
>> Ugh, but that hard codes an assumption that a domain cannot have more
>> that 32 irqs.
>>
>> /me goes to dig into irq_domain code...
>
> No, it hard codes that generic irq chip is 32 interrupts at most which
> is already the case. That's why the TZIC uses 5 generic irq chip instances.
Oops, you're right. I wasn't paying close enough attention. Sorry for
the noise.
g.
More information about the linux-arm-kernel
mailing list