[PATCHV2 REPOST 1/7] ARM: OMAP3 PM: correct enable/disable of daisy io chain

[Vishwanath BS]

From: Mohan V <mohanv at ti.com>

Currently the enabling and disabling of IO Daisy chain is not
according to the TRM. The below steps are followed to enable/
disable the IO chain according to the "Sec 3.5.7.2.2
I/O Wake-Up Mechanism" in OMAP3630 Public TRM[1].

Steps to enable IO chain:
[a] Set PM_WKEN_WKUP.EN_IO bit
[b] Set the PM_WKEN_WKUP.EN_IO_CHAIN bit
[c] Poll for PM_WKST_WKUP.ST_IO_CHAIN.
[d] When ST_IO_CHAIN bit set to 1, clear PM_WKEN_WKUP.EN_IO_CHAIN
[e] Clear ST_IO_CHAIN bit.

Steps to disable IO chain:
[a] Clear PM_WKEN_WKUP.EN_IO_CHAIN bit
[b] Clear PM_WKEN_WKUP.EN_IO bit
[c] Clear PM_WKST_WKUP.ST_IO bit by writing 1 to it.

Step [e] & [c] in each case can be skipped, as these are handled
by the PRCM interrupt handler later.

[1] http://focus.ti.com/pdfs/wtbu/OMAP36xx_ES1.x_PUBLIC_TRM_vV.zip

Signed-off-by: Mohan V <mohanv at ti.com>
Signed-off-by: Vishwanath BS <vishwanath.bs at ti.com>
---
 arch/arm/mach-omap2/pm34xx.c |    7 ++++---
 1 files changed, 4 insertions(+), 3 deletions(-)

diff --git a/arch/arm/mach-omap2/pm34xx.c b/arch/arm/mach-omap2/pm34xx.c
index 3b9edc8..074688b 100644
--- a/arch/arm/mach-omap2/pm34xx.c
+++ b/arch/arm/mach-omap2/pm34xx.c
@@ -105,16 +105,17 @@ static void omap3_enable_io_chain(void)
 	/* Do a readback to assure write has been done */
 	omap2_prm_read_mod_reg(WKUP_MOD, PM_WKEN);
 
-	while (!(omap2_prm_read_mod_reg(WKUP_MOD, PM_WKEN) &
+	while (!(omap2_prm_read_mod_reg(WKUP_MOD, PM_WKST) &
 		 OMAP3430_ST_IO_CHAIN_MASK)) {
 		timeout++;
 		if (timeout > 1000) {
 			pr_err("Wake up daisy chain activation failed.\n");
 			return;
 		}
-		omap2_prm_set_mod_reg_bits(OMAP3430_ST_IO_CHAIN_MASK,
-					   WKUP_MOD, PM_WKEN);
 	}
+	omap2_prm_clear_mod_reg_bits(OMAP3430_EN_IO_CHAIN_MASK, WKUP_MOD,
+			PM_WKEN);
+
 }
 
 static void omap3_disable_io_chain(void)
-- 
1.7.0.4