[PATCH 1/7] arm/imx6: add imx6q sabrelite board support

[Richard Zhao]

On Mon, Dec 12, 2011 at 01:39:06PM -0700, Troy Kisky wrote:
> On 12/11/2011 10:40 PM, Shawn Guo wrote:
> >>+	memory {
> >>+		reg =<0x10000000 0x40000000>;
> >>+	};
> >>+
> >>+	soc {
> >>+		aips-bus at 02100000 { /* AIPS2 */
> >>+			enet at 02188000 {
> >>+				phy-mode = "rgmii";
> >>+				local-mac-address = [01 04 9F 01 1B 61];
> >Do we still have no way to figure the mac address from hardware setup
> >(fuse or something) on sabrelite board?
> >
> >
> U-boot now has support for blowing the mac fuses.
> 
> i.e.
> imxotp blow --force 23 0019 ; imxotp blow --force 22 B800e1f5
> 
> for a mac of 00:19:b8:00:e1:f5
> 
> Most boards already have this done.
It's software issue here. When use DT, we don't still have patch to
read fuse and pass mac address to fec driver. Currently, we can use
bootargs fec.macaddr.

Thanks
Richard
> 
> Troy
> 
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
>