[PATCH 3/3] ide/at91: use new introduce smc accessor

[Ryan Mallon]

On 09/12/11 02:23, Jean-Christophe PLAGNIOL-VILLARD wrote:

> this will allow to use the pata_at91 on a single zImage
> 
> Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
> Cc: Nicolas Ferre <nicolas.ferre at atmel.com>
> Cc: linux-ide at vger.kernel.org


Couple of minor comments below,

~Ryan

> ---
> Hi,
> 
> 	it's depends on other patch for AT91 can we apply via at91
> 
> Best Regards,
> J.
>  drivers/ide/at91_ide.c |   65 +++++++++++++++++++++++++++--------------------
>  1 files changed, 37 insertions(+), 28 deletions(-)
> 
> diff --git a/drivers/ide/at91_ide.c b/drivers/ide/at91_ide.c
> index 41d4155..407595b 100644
> --- a/drivers/ide/at91_ide.c
> +++ b/drivers/ide/at91_ide.c
> @@ -59,41 +59,50 @@
>  #define ALT_MODE	0x00e00000
>  #define REGS_SIZE	8
>  
> -#define enter_16bit(cs, mode) do {					\
> -	mode = at91_sys_read(AT91_SMC_MODE(cs));			\
> -	at91_sys_write(AT91_SMC_MODE(cs), mode | AT91_SMC_DBW_16);	\
> -} while (0)
> +static inline void enter_16bit(int cs, struct sam9_smc_config *smc)
> +{
> +	sam9_smc_read_mode(0, cs, smc);
> +	smc->mode = (smc->mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_16;
> +	sam9_smc_write_mode(0, cs, smc);
> +}
>  
> -#define leave_16bit(cs, mode) at91_sys_write(AT91_SMC_MODE(cs), mode);
> +static inline void leave_16bit(int cs, struct sam9_smc_config *smc)
> +{
> +	smc->mode = (smc->mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_8;
> +	sam9_smc_write_mode(0, cs, smc);
> +}
>  
>  static void set_smc_timings(const u8 chipselect, const u16 cycle,
>  			    const u16 setup, const u16 pulse,
>  			    const u16 data_float, int use_iordy)
>  {
> -	unsigned long mode = AT91_SMC_READMODE | AT91_SMC_WRITEMODE |
> +	struct sam9_smc_config smc;
> +
> +	smc.mode = AT91_SMC_READMODE | AT91_SMC_WRITEMODE |
>  			     AT91_SMC_BAT_SELECT;
>  
>  	/* disable or enable waiting for IORDY signal */
>  	if (use_iordy)
> -		mode |= AT91_SMC_EXNWMODE_READY;
> +		smc.mode |= AT91_SMC_EXNWMODE_READY;
>  
> -	/* add data float cycles if needed */
> -	if (data_float)
> -		mode |= AT91_SMC_TDF_(data_float);
> +	/* add data ofloat cycles if needed */


Typo: ofloat -> float?

> +	smc.tdf_cycles = data_float;
>  
> -	at91_sys_write(AT91_SMC_MODE(chipselect), mode);
> +	/* write SMC Setup Register */


This comment is no longer correct.

> +	smc.nrd_setup = setup;
> +	smc.nwe_setup = smc.nrd_setup;
> +	smc.ncs_read_setup = 0;
> +	smc.ncs_write_setup = smc.ncs_read_setup;
> +	/* write SMC Pulse Register */


Nor is this one.

> +	smc.nrd_pulse = pulse;
> +	smc.nwe_pulse = smc.nrd_pulse;
> +	smc.ncs_read_pulse = cycle;
> +	smc.ncs_write_pulse = smc.ncs_read_pulse;
> +	/* write SMC Cycle Register */


or this one.

> +	smc.read_cycle = cycle;
> +	smc.write_cycle = smc.read_cycle;
>  
> -	/* setup timings in SMC */
> -	at91_sys_write(AT91_SMC_SETUP(chipselect), AT91_SMC_NWESETUP_(setup) |
> -						   AT91_SMC_NCS_WRSETUP_(0) |
> -						   AT91_SMC_NRDSETUP_(setup) |
> -						   AT91_SMC_NCS_RDSETUP_(0));
> -	at91_sys_write(AT91_SMC_PULSE(chipselect), AT91_SMC_NWEPULSE_(pulse) |
> -						   AT91_SMC_NCS_WRPULSE_(cycle) |
> -						   AT91_SMC_NRDPULSE_(pulse) |
> -						   AT91_SMC_NCS_RDPULSE_(cycle));
> -	at91_sys_write(AT91_SMC_CYCLE(chipselect), AT91_SMC_NWECYCLE_(cycle) |
> -						   AT91_SMC_NRDCYCLE_(cycle));
> +	sam9_smc_configure(0, chipselect, &smc);


Check return value?

>  }
>  
>  static unsigned int calc_mck_cycles(unsigned int ns, unsigned int mck_hz)
> @@ -146,15 +155,15 @@ static void at91_ide_input_data(ide_drive_t *drive, struct ide_cmd *cmd,
>  	ide_hwif_t *hwif = drive->hwif;
>  	struct ide_io_ports *io_ports = &hwif->io_ports;
>  	u8 chipselect = hwif->select_data;
> -	unsigned long mode;
> +	struct sam9_smc_config smc;
>  
>  	pdbg("cs %u buf %p len %d\n", chipselect, buf, len);
>  
>  	len++;
>  
> -	enter_16bit(chipselect, mode);
> +	enter_16bit(chipselect, &smc);
>  	readsw((void __iomem *)io_ports->data_addr, buf, len / 2);
> -	leave_16bit(chipselect, mode);
> +	leave_16bit(chipselect, &smc);
>  }
>  
>  static void at91_ide_output_data(ide_drive_t *drive, struct ide_cmd *cmd,
> @@ -163,13 +172,13 @@ static void at91_ide_output_data(ide_drive_t *drive, struct ide_cmd *cmd,
>  	ide_hwif_t *hwif = drive->hwif;
>  	struct ide_io_ports *io_ports = &hwif->io_ports;
>  	u8 chipselect = hwif->select_data;
> -	unsigned long mode;
> +	struct sam9_smc_config smc;
>  
>  	pdbg("cs %u buf %p len %d\n", chipselect,  buf, len);
>  
> -	enter_16bit(chipselect, mode);
> +	enter_16bit(chipselect, &smc);
>  	writesw((void __iomem *)io_ports->data_addr, buf, len / 2);
> -	leave_16bit(chipselect, mode);
> +	leave_16bit(chipselect, &smc);
>  }
>  
>  static void at91_ide_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)