AT91: PIO base-address should be calculated by processor-specific code

[Jean-Christophe PLAGNIOL-VILLARD]

On 16:11 Fri 29 Apr     , Andrew Victor wrote:
> For supporting multiple AT91 processors in a single kernel image, the
> base-address of the system peripherals is processor-dependent.  The GPIO
> driver should therefore not reference AT91_VA_BASE_SYS, but rather the
> correct peripheral base-address needs to be provided by the
> processor-specific initialization code.
please don't I swtich to early device and clkdev thye are in confilt
and this is clean inside

Best Regards,
J.