zaurus: mmcblk0: error -110

[Cyril Hrubis]

Hi!
When I insert the mmc card to zaurus, it gets properly detected and prints some
info into console. Mounting reading/writing files works fine.

However when the card is removed (doesn't need to be mounted before), the
removal is most likely not detected, so when I insert it again, no info is
printed into console and moreover when I try to mount it zaurus goes into
infinite loop printing:

Buffer I/O error on device mmcblk0p1, logical block 9
mmcblk0: error -110 sending status command
mmcblk0: error -110 sending read/write command, response 0xb00, card status 0xb00
end_request: I/O error, dev mmcblk0, sector 257
Buffer I/O error on device mmcblk0p1, logical block 10
mmcblk0: error -110 sending status command
mmcblk0: error -110 sending read/write command, response 0xb00, card status 0xb00
end_request: I/O error, dev mmcblk0, sector 258
Buffer I/O error on device mmcblk0p1, logical block 11
mmcblk0: error -110 sending status command
mmcblk0: error -110 sending read/write command, response 0xb00, card status 0xb00
end_request: I/O error, dev mmcblk0, sector 259
Buffer I/O error on device mmcblk0p1, logical block 12
mmcblk0: error -110 sending status command
mmcblk0: error -110 sending read/write command, response 0xb00, card status 0xb00
...

Related part of the .config:

#
# OTG and related infrastructure
#
# CONFIG_USB_GPIO_VBUS is not set
# CONFIG_USB_ULPI is not set
# CONFIG_NOP_USB_XCEIV is not set
CONFIG_MMC=y
# CONFIG_MMC_DEBUG is not set
CONFIG_MMC_UNSAFE_RESUME=y
# CONFIG_MMC_CLKGATE is not set

#
# MMC/SD/SDIO Card Drivers
#
CONFIG_MMC_BLOCK=y
CONFIG_MMC_BLOCK_MINORS=8
CONFIG_MMC_BLOCK_BOUNCE=y
# CONFIG_SDIO_UART is not set
# CONFIG_MMC_TEST is not set

#
# MMC/SD/SDIO Host Controller Drivers
#
CONFIG_MMC_PXA=y

-- 
metan