[PATCH] ARM: S5PV210: Add audio support to Goni and Aquila board

[Kukjin Kim]

Chanwoo Choi wrote:
> 
> Dear Ben,
> 
> Don't you have any comment this patch?
> Please give your commont for this patch.
> 
> Chanwoo Choi
> 
> Chanwoo Choi wrote:
> > This patch the I2C board information for the WM8994 used in the
Goni/Aquila
> > as audio codec and adds the I2C/I2S platform drivers. Additionlly, to
> > control power consumption have registerd the voltage consumer of WM8994
> > to the regulator framework.
> >
> > Additionally, I explain the constraints of the regulator of WM8994
codec.
> > All these consumer supply of WM8994 codec connected the
regulator(VCC_1.8V)
> > on a circuit diagram. "VCC_1.8V" regulator is always enabled, because it
is
> > used to many devices on Goni/Aquila board. This is required especially
> > when there are many devices physically attached to "VCC_1.8V" and some
of
> > they did not "register" as consumers to "VCC_1.8V". "VCC_1.8V" might be
> > turned off by those who are registered while "unregistered" are still
active.
> >
> > Signed-off-by : Chanwoo Choi <cw00.choi at samsung.com>
> > Signed-off-by : Joonyoung Shim <jy0922.shim at samsung.com>
> > Signed-off-by : Kyungmin Park <kyungmin.park at samsung.com>
> > ---

Hmm...

Please add my e-mail for S5P series later...
I found this patch just now :-(

Will check soon.

Thanks.

Best regards,
Kgene.
--
Kukjin Kim <kgene.kim at samsung.com>, Senior Engineer,
SW Solution Development Team, Samsung Electronics Co., Ltd.