[PATCH v2 0/4] tidspbridge: SCM layer violation fixes

[Felipe Contreras]

On Tue, Oct 26, 2010 at 7:15 PM, Omar Ramirez Luna <omar.ramirez at ti.com> wrote:
> This is the patch series shared by Paul, for a short term fix to
> a compile break due SCM layer layer violations from tidspbridge
> driver, where the latter is used to write directly into registers
> and use SCM layer macros, among other layer bypassing.
>
> patch: "staging: tidspbridge: use new SCM DSP boot control fns"
> was split from its original version, it is meant to be on hold until
> the rest of the series gets upstreamed and can be found in the
> staging tree (unless best advice is given).
>
> Paul Walmsley (4):
>  OMAP: control: add functions for DSP boot address/mode control
>  OMAP3: PM: update DSP reset code to use new SCM DSP boot control
>    functions
>  OMAP: dsp: convert OMAP3430 adaptation layer to use new SCM DSP boot
>    control fns
>  staging: tidspbridge: use new SCM DSP boot control fns
>
>  arch/arm/mach-omap2/control.c                 |   51 ++++++++++++++++++++++
>  arch/arm/mach-omap2/control.h                 |   16 ++++---
>  arch/arm/mach-omap2/dsp.c                     |    4 ++
>  arch/arm/mach-omap2/pm34xx.c                  |    6 +-
>  arch/arm/plat-omap/include/plat/dsp.h         |    4 ++
>  arch/arm/plat-omap/include/plat/iva2_dsp.h    |   56 +++++++++++++++++++++++++

Why not use the already existing dsp.h?

-- 
Felipe Contreras