[GITT PULL] AT91: 2.6.37 merge window

[Nicolas Ferre]

Hi Linus,

Could you please pull the following:

  git://github.com/at91linux/linux-2.6-at91.git for_linus

This contains a set of AT91 updates for 2.6.37 merge 
window. All has been discussed on the arm-linux mailing 
list. It is based on your tree:
commit b18cae4224bde7e5a332c19bc99247b2098ea232

Nicolas Ferre (7):
      AT91: trivial: align comment of at91sam9g20_reset with one more tab
      AT91: reset routine cleanup, remove not needed icache flush
      AT91: reset: extend alternate reset procedure to several chips
      AT91: pm: use plain cpu_do_idle() for "wait for interrupt"
      AT91: pm: make sure that r0 is 0 when dealing with cache operations
      at91/atmel-mci: inclusion of sd/mmc driver in at91sam9g45 chip and board
      AT91: rtc: enable built-in RTC in Kconfig for at91sam9g45 family

Peter Gsellmann (1):
      AT91: add board support for Pcontrol_G20

Peter Horton (1):
      AT91: Fix AT91SAM9G20 reset as per the errata in the data sheet

 arch/arm/configs/pcontrol_g20_defconfig  |  175 ++++++++++++++++
 arch/arm/mach-at91/Kconfig               |    6 +
 arch/arm/mach-at91/Makefile              |   13 +-
 arch/arm/mach-at91/at91sam9260.c         |    7 +-
 arch/arm/mach-at91/at91sam9261.c         |    7 +-
 arch/arm/mach-at91/at91sam9263.c         |    7 +-
 arch/arm/mach-at91/at91sam9_alt_reset.S  |   48 +++++
 arch/arm/mach-at91/at91sam9g45_devices.c |  165 +++++++++++++++
 arch/arm/mach-at91/at91sam9rl.c          |    7 +-
 arch/arm/mach-at91/board-pcontrol-g20.c  |  322 ++++++++++++++++++++++++++++++
 arch/arm/mach-at91/board-sam9m10g45ek.c  |   24 +++
 arch/arm/mach-at91/generic.h             |    3 +
 arch/arm/mach-at91/pm.c                  |   15 +-
 arch/arm/mach-at91/pm.h                  |    5 +
 arch/arm/mach-at91/pm_slowclock.S        |    1 +
 drivers/mmc/host/Kconfig                 |    2 +-
 drivers/rtc/Kconfig                      |   12 +-
 17 files changed, 778 insertions(+), 41 deletions(-)
 create mode 100644 arch/arm/configs/pcontrol_g20_defconfig
 create mode 100644 arch/arm/mach-at91/at91sam9_alt_reset.S
 create mode 100644 arch/arm/mach-at91/board-pcontrol-g20.c

Thanks a lot, best regards,
-- 
Nicolas Ferre