[PATCH v2] Input: Make ADS7846 independent on regulator

[Dmitry Torokhov]

On Tue, Oct 05, 2010 at 09:40:38AM -0700, Mark Brown wrote:
> On Tue, Oct 05, 2010 at 09:16:08AM -0700, Dmitry Torokhov wrote:
> > On Tue, Oct 05, 2010 at 08:49:07AM +0200, Igor Grinberg wrote:
> 
> > > You want each platform, that does not have a special regulated power supply
> > > for the ads7846, to define a dummy regulator just to cope with that artificial
> > > dependency of the device driver?
> > > I think it is a waste and big code duplication in each platform
> > > that does not have that special regulator.
> 
> It's a pretty good fit for most current systems - with current hardware
> you will normally have some software control for the vast majority of
> the regulators on the board if you have regulator control at all since
> that's the way PMICs have gone.  Having a complete map of the regulator
> usage in the system is useful since it allows us to do optimisations
> like powering down idle regulators much more readily.
> 
> > I tend to agree, however I think that original patch that simply ignored
> > failures from regulator_get() is not the best option either. Can we have
> > a flag in platform data indicating that the board does not employ a
> > regulator? Then we could retain the hard failure in cases when we expect
> > regulator to be present while allowing to continue on boards that do not
> > have it.
> 
> I really don't think it's a good idea to add this code to every single
> regulator using driver - this seems like an enormous waste of time and
> code complexity cost.  I have suggested several times that we should
> extend the dummy regulator mode so that boards can enable it from code
> as well as users enable it from Kconfig, I'm not sure why everyone is so
> keen on bodging this in drivers.

It all depends on what instances you expect to encounted more often -
drivers or boards without regulators...

-- 
Dmitry