[PATCH] ulpi: add i.MX25 & 35 internal PHY ID

[Sergei Shtylyov]

Hello.

Eric Bénard wrote:

> without this patch, the initialization of the OTG port in host mode
> fails with :
> ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
> mxc-ehci mxc-ehci.0: initializing i.MX USB Controller
> ULPI transceiver vendor/product ID 0x0000/0x0000
> ULPI ID does not match any known transceiver.
> mxc-ehci mxc-ehci.0: unable to init transceiver, probably missing

> Signed-off-by: Eric Bénard <eric at eukrea.com>
> ---
>  drivers/usb/otg/ulpi.c |    5 ++++-
>  1 files changed, 4 insertions(+), 1 deletions(-)

    You should have CC'ed linux-usb at vger.kernel.org.

> diff --git a/drivers/usb/otg/ulpi.c b/drivers/usb/otg/ulpi.c
> index ccc8195..e802e44 100644
> --- a/drivers/usb/otg/ulpi.c
> +++ b/drivers/usb/otg/ulpi.c
> @@ -34,7 +34,10 @@
>  /* ULPI hardcoded IDs, used for probing */
>  static unsigned int ulpi_ids[] = {
>  	ULPI_ID(0x04cc, 0x1504),	/* NXP ISP1504 */
> -	ULPI_ID(0x0424, 0x0006),        /* SMSC USB3319 */
> +	ULPI_ID(0x0424, 0x0006),	/* SMSC USB3319 */
> +#if (defined(CONFIG_ARCH_MX25) || defined(CONFIG_ARCH_MX35))
> +	ULPI_ID(0x0000, 0x0000),	/* i.MX25 & i.MX35 internal PHY */
> +#endif

    I don't know why this table is at all used in the first place. IMO, checking 
for the vendor/device ID serves no purpose...

WBR, Sergei