[PATCHv3 1/6] omap3: Add external VBUS power switch and overcurrent detect on IGEP v2 board.

Enric Balletbo i Serra eballetbo at gmail.com
Fri Oct 1 17:09:04 EDT 2010


GPIO for various devices are missing from the board initialization.
This patch adds support for the VBUS and over current gpios.  Without this
patch, input/outputs from these two sources are ignored.

Signed-off-by: Enric Balletbo i Serra <eballetbo at gmail.com>
---
 arch/arm/mach-omap2/board-igep0020.c |   16 ++++++++++++++++
 1 files changed, 16 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-omap2/board-igep0020.c b/arch/arm/mach-omap2/board-igep0020.c
index 175f043..07dbdb7 100644
--- a/arch/arm/mach-omap2/board-igep0020.c
+++ b/arch/arm/mach-omap2/board-igep0020.c
@@ -274,6 +274,22 @@ static int igep2_twl_gpio_setup(struct device *dev,
 	igep2_vmmc1_supply.dev = mmc[0].dev;
 	igep2_vmmc2_supply.dev = mmc[1].dev;
 
+	/*
+	 * REVISIT: need ehci-omap hooks for external VBUS
+	 * power switch and overcurrent detect
+	 */
+	if ((gpio_request(gpio + 1, "GPIO_EHCI_NOC") < 0) ||
+	    (gpio_direction_input(gpio + 1) < 0))
+		pr_err("IGEP2: Could not obtain gpio for EHCI NOC");
+
+	/*
+	 * TWL4030_GPIO_MAX + 0 == ledA, GPIO_USBH_CPEN
+	 * (out, active low)
+	 */
+	if ((gpio_request(gpio + TWL4030_GPIO_MAX, "GPIO_USBH_CPEN") < 0) ||
+	    (gpio_direction_output(gpio + TWL4030_GPIO_MAX, 0) < 0))
+		pr_err("IGEP2: Could not obtain gpio for USBH_CPEN");
+
 	return 0;
 };
 
-- 
1.7.0.4




More information about the linux-arm-kernel mailing list