S3C2416 clock tree

[Sergey Lapin]

On Tue, Nov 09, 2010 at 06:57:02PM +0300, Dron Gus wrote:

Added Ben Dooks and Kukjin Kim to Cc:
> Hi!
> 
> I work with custom board based on s3c2416 SoC. I'm trying to make
> cpufreq work. I wrote the driver based on cpu-freq.c from
> mach-s3c2410.
> On kernel start i get error message:
> cpufreq: failed to get clock 'armclk'
> s3c2416_cpufreq_add: failed to get clocks
> So i have to add dummy 'armclk' and some dummy clk_ops functions.
> Now cpufreq starts, and tries to change freqs, calling to my
> s3c2416_cpufreq_calcdivs. But the problem is that it passes wrong fclk
> value. Pll rums on 800 MHz, armclk = 400 MHz, hclk = 133, pclk = 66. I
> get fclk = 400 MHz. It is two time smaller than mpll.
> I can not understood is value of fclk the same as armclk or as mpll?
> To count correct armclk divider i must know mpll freq. But as i see in
> s3c2443_common_setup_clocks and in s3c24xx_setup_clocks, mpll rate is
> set the same as fclk, but fclk = pll / get_fdiv(clkdiv0);
> So there is three ways to solve this problem, as i see:
> 1) pass one more argument to s3c24xx_setup_clocks with value of mpll.
> This will break to many mach-s3c****
> 2) write get_rate for mpll clock and set mpll as a parent for fclk.
> Problem is that PLLs are diferent on diferent s3c SoCs.
> 3) the same as 2, but use function get_mpll, wich is passed to
> s3c2443_common_setup_clocks.
> 
> Witch way is preferred?
> 
> Thanks.
> 
> Andrey.
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel