[PATCH 4/4] pata_samsung: Add Samsung PATA controller driver

Ben Dooks ben-linux at fluff.org
Thu May 27 04:57:14 EDT 2010


On Thu, May 27, 2010 at 05:43:47PM +0900, Jassi Brar wrote:
> On Thu, May 27, 2010 at 5:22 PM, Kukjin Kim <kgene.kim at samsung.com> wrote:
> > From: Abhilash Kesavan <a.kesavan at samsung.com>
> >
> > Adds support for the Samsung PATA controller. This driver is based on the
> > Libata subsystem and references the earlier patches sent for IDE subsystem.
> >
> > Signed-off-by: Abhilash Kesavan <a.kesavan at samsung.com>
> > Signed-off-by: Kukjin Kim <kgene.kim at samsung.com>
> > ---
> >  drivers/ata/Kconfig        |    9 +
> >  drivers/ata/Makefile       |    1 +
> >  drivers/ata/pata_samsung.c |  591
> 
> Fasten your seat belts before reading further....
> 
> Rather than generic 'samsung', I would suggest the driver named
> after the SoC, that is supported first(chronologically) in mainline kernel.
> All newer SoCs should be simply taken to contain the controller of that SoC.
> Otherwise, the same naming problem comes back to haunt us should
> Samsung decides to use a different IP in future SoCs. What would we
> call that driver? pata_samsung_v2.c ?

I'm not so bothered, but it could be pata_samsung_cfcon or anything,
a new block could be called pata_samsung_v2 or fred for all I really
care about this.
 
> my two sparks
> Jassi

-- 
-- 
Ben

Q:      What's a light-year?
A:      One-third less calories than a regular year.




More information about the linux-arm-kernel mailing list