[PATCH 24/33] Removing dead ARCH_GUMSTIX_ORIG

[Eric Miao]

On Thu, Jul 1, 2010 at 12:01 AM, Christoph Egger <siccegge at cs.fau.de> wrote:
> ARCH_GUMSTIX_ORIG doesn't exist in Kconfig, therefore removing all
> references for it from the source code.
>
> Signed-off-by: Christoph Egger <siccegge at cs.fau.de>

Acked-by: Eric Miao <eric.y.miao at gmail.com>

Cc'ed Jaya Kumar for additional thoughts.

> ---
>  arch/arm/mach-pxa/include/mach/gumstix.h |   12 +-----------
>  1 files changed, 1 insertions(+), 11 deletions(-)
>
> diff --git a/arch/arm/mach-pxa/include/mach/gumstix.h b/arch/arm/mach-pxa/include/mach/gumstix.h
> index 06abd41..9b89868 100644
> --- a/arch/arm/mach-pxa/include/mach/gumstix.h
> +++ b/arch/arm/mach-pxa/include/mach/gumstix.h
> @@ -14,25 +14,15 @@
>
>  /*
>  GPIOn - Input from MAX823 (or equiv), normalizing USB +5V into a clean
> -interrupt signal for determining cable presence. On the original gumstix,
> -this is GPIO81, and GPIO83 needs to be defined as well. On the gumstix F,
> +interrupt signal for determining cable presence. On the gumstix F,
>  this moves to GPIO17 and GPIO37. */
>
>  /* GPIOx - Connects to USB D+ and used as a pull-up after GPIOn
>  has detected a cable insertion; driven low otherwise. */
>
> -#ifdef CONFIG_ARCH_GUMSTIX_ORIG
> -
> -#define GPIO_GUMSTIX_USB_GPIOn         81
> -#define GPIO_GUMSTIX_USB_GPIOx         83
> -
> -#else
> -
>  #define GPIO_GUMSTIX_USB_GPIOn         35
>  #define GPIO_GUMSTIX_USB_GPIOx         41
>
> -#endif
> -
>  /* usb state change */
>  #define GUMSTIX_USB_INTR_IRQ           IRQ_GPIO(GPIO_GUMSTIX_USB_GPIOn)
>
> --
> 1.7.0.4
>
>