[PATCH 0/9] Initial multi-omap support for omap4

[Tony Lindgren]

* Shilimkar, Santosh <santosh.shilimkar at ti.com> [100130 04:49]:
> > > Hi all,
> > >
> > > These patches allow compiling in also omap4 into the multi-omap
> > > configuration. As I don't yet have omap4, I've only boot tested
> > > these on omap2 and omap3.
> > >
> > > Somebody with an omap4 board please boot test these with the
> > > omap3_defconfig and see what happens.. You might want to enable
> > > DEBUG_LL and EARLY_PRINTK with earlyprintk on the cmdline too.
> > Looks like this series have some dependent series because it doesn't
> > apply on mainline.
> > 
> > So I tested this directly on linux-omap "multi-omap4" branch. It boots sufficiently
> > but doesn't proceed after "brd_init". Didn't get much time to debug so attached log
> 
> Stand alone omap_4430sdp_defconfig also didn't fully boot on the linux-omap "multi-omap4".
> The log below shows that the serial platform data isn't configured correctly. 
> 
> <6>io scheduler deadline registered
> <6>io scheduler cfq registered (default)
> <6>Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
> <6>serial8250.0: ttyS0 at MMIO 0x4806a000 (irq = 104) is a ST16654
> <6>serial8250.1: ttyS0 at MMIO 0x4806a000 (irq = 105) is a ST16654
> 
> Below patch to fix the boot for omap_4430sdp_defconfig. Small typo really.
> 
> diff --git a/arch/arm/plat-omap/include/plat/serial.h b/arch/arm/plat-omap/inclu
> index 67ffa08..83dce4c 100644
> --- a/arch/arm/plat-omap/include/plat/serial.h
> +++ b/arch/arm/plat-omap/include/plat/serial.h
> @@ -33,7 +33,7 @@
> 
>  /* OMAP4 serial ports */
>  #define OMAP4_UART1_BASE       OMAP2_UART1_BASE
> -#define OMAP4_UART2_BASE       OMAP2_UART1_BASE
> +#define OMAP4_UART2_BASE       OMAP2_UART2_BASE
>  #define OMAP4_UART3_BASE       0x48020000
>  #define OMAP4_UART4_BASE       0x4806e000

Heh OK :) Sounds like at this point it makes sense to merge
that into the original patch redo omap-for-linus partially.

Can I also add your Acked-by for these patches then?
 
> For multi-omap build, for now I need to disable 
> [*] Reset unused clocks during boot

Sounds like omap4 has some clocks left on from the bootloader
that it should clk_get and clk_enable during init. That should
be easy to track if you boot with "debug" in your cmdline and
take a look at the list of unused clocks that are shut down
with late_initcall.
 
> With this OMAP4430 boots with omap3_defconfig :)

Cool, thanks, good to hear!

Now the only omap2/3/4 that's not booting with omap3_defconfig
is 2430 because of the different clock offsets compare dot 2420.
That should get fixed eventually though.

Regards,

Tony