[PATCH] ARM: SAMSUNG: Move pm-gpio into plat-samsung

[Ben Dooks]

Move the pm-gpio code into plat-samsung.

Note, this should be changed later to properly compile the 4bit code if
the 4bit settings are enabled.

Signed-off-by: Ben Dooks <ben-linux at fluff.org>
---
 arch/arm/plat-s3c/Makefile                    |    1 -
 arch/arm/plat-samsung/Makefile                |    4 ++++
 arch/arm/{plat-s3c => plat-samsung}/pm-gpio.c |    0
 3 files changed, 4 insertions(+), 1 deletions(-)
 rename arch/arm/{plat-s3c => plat-samsung}/pm-gpio.c (100%)

diff --git a/arch/arm/plat-s3c/Makefile b/arch/arm/plat-s3c/Makefile
index ea4a001..ac12ba5 100644
--- a/arch/arm/plat-s3c/Makefile
+++ b/arch/arm/plat-s3c/Makefile
@@ -22,7 +22,6 @@ obj-$(CONFIG_S3C_DMA)		+= dma.o
 # PM support
 
 obj-$(CONFIG_PM)		+= pm.o
-obj-$(CONFIG_PM)		+= pm-gpio.o
 obj-$(CONFIG_S3C2410_PM_CHECK)	+= pm-check.o
 
 # PWM support
diff --git a/arch/arm/plat-samsung/Makefile b/arch/arm/plat-samsung/Makefile
index 1425a45..0310e04 100644
--- a/arch/arm/plat-samsung/Makefile
+++ b/arch/arm/plat-samsung/Makefile
@@ -36,3 +36,7 @@ obj-$(CONFIG_S3C_DEV_FB)	+= dev-fb.o
 obj-$(CONFIG_S3C_DEV_USB_HOST)	+= dev-usb.o
 obj-$(CONFIG_S3C_DEV_USB_HSOTG)	+= dev-usb-hsotg.o
 obj-$(CONFIG_S3C_DEV_NAND)	+= dev-nand.o
+
+# PM support
+
+obj-$(CONFIG_PM)		+= pm-gpio.o
diff --git a/arch/arm/plat-s3c/pm-gpio.c b/arch/arm/plat-samsung/pm-gpio.c
similarity index 100%
rename from arch/arm/plat-s3c/pm-gpio.c
rename to arch/arm/plat-samsung/pm-gpio.c
-- 
1.6.0.4