[PATCH 10/23] omap3: Add platform init code for EHCI driver on IGEP v2

[Tony Lindgren]

From: Enric Balletbo i Serra <eballetbo at iseebcn.com>

Add platform init code for EHCI driver on IGEP v2

Signed-off-by: Enric Balletbo i Serra <eballetbo at iseebcn.com>
Signed-off-by: Tony Lindgren <tony at atomide.com>
---
 arch/arm/mach-omap2/board-igep0020.c |   12 ++++++++++++
 1 files changed, 12 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-omap2/board-igep0020.c b/arch/arm/mach-omap2/board-igep0020.c
index 71488b2..f6102c7 100644
--- a/arch/arm/mach-omap2/board-igep0020.c
+++ b/arch/arm/mach-omap2/board-igep0020.c
@@ -213,6 +213,17 @@ static int __init igep2_i2c_init(void)
 	return 0;
 }
 
+static struct ehci_hcd_omap_platform_data ehci_pdata __initconst = {
+	.port_mode[0] = EHCI_HCD_OMAP_MODE_UNKNOWN,
+	.port_mode[1] = EHCI_HCD_OMAP_MODE_PHY,
+	.port_mode[2] = EHCI_HCD_OMAP_MODE_UNKNOWN,
+
+	.phy_reset = true,
+	.reset_gpio_port[0] = -EINVAL,
+	.reset_gpio_port[1] = IGEP2_GPIO_USBH_NRESET,
+	.reset_gpio_port[2] = -EINVAL,
+};
+
 #ifdef CONFIG_OMAP_MUX
 static struct omap_board_mux board_mux[] __initdata = {
 	{ .reg_offset = OMAP_MUX_TERMINATOR },
@@ -227,6 +238,7 @@ static void __init igep2_init(void)
 	igep2_i2c_init();
 	omap_serial_init();
 	usb_musb_init();
+	usb_ehci_init(&ehci_pdata);
 
 	igep2_init_smsc911x();