[PATCH v2 1/8] ARM: mx5: use config to define boot related addresses

[Richard Zhao]

On Wed, Dec 29, 2010 at 09:14:19AM +0100, Uwe Kleine-König wrote:
> On Wed, Dec 29, 2010 at 03:30:23PM +0800, Richard Zhao wrote:
> > Signed-off-by: Richard Zhao <richard.zhao at freescale.com>
> > ---
> > Because common clock is change, I don't send out mx50 clock and board level code.
> > But sure I tested the patch series using the clock/board code.
> >  arch/arm/mach-mx5/Makefile.boot |    6 +++---
> >  1 files changed, 3 insertions(+), 3 deletions(-)
> > 
> > diff --git a/arch/arm/mach-mx5/Makefile.boot b/arch/arm/mach-mx5/Makefile.boot
> > index 9939a19..388d2e8 100644
> > --- a/arch/arm/mach-mx5/Makefile.boot
> > +++ b/arch/arm/mach-mx5/Makefile.boot
> > @@ -1,3 +1,3 @@
> > -   zreladdr-y	:= 0x90008000
> > -params_phys-y	:= 0x90000100
> > -initrd_phys-y	:= 0x90800000
> > +   zreladdr-$(CONFIG_SOC_IMX51)	:= 0x90008000
> > +params_phys-$(CONFIG_SOC_IMX51)	:= 0x90000100
> > +initrd_phys-$(CONFIG_SOC_IMX51)	:= 0x90800000
> I'd prefer to use CONFIG_MACH_MX51 here.
ok

Richard
> 
> Uwe
> 
> -- 
> Pengutronix e.K.                           | Uwe Kleine-König            |
> Industrial Linux Solutions                 | http://www.pengutronix.de/  |
>