[PATCH 2/5] OMAP4: PM: Do not assume clkdm supports hw transitions

[Kevin Hilman]

Benoit Cousson <b-cousson at ti.com> writes:

> From: Rajendra Nayak <rnayak at ti.com>
>
> omap_set_pwrdm_state today assumes a clkdm supports hw_auto
> transitions and hence leaves some which do not support this
> in sw wkup state preventing low power transitions.
>
> Signed-off-by: Rajendra Nayak <rnayak at ti.com>
> Signed-off-by: Santosh Shilimkar <santosh.shilimkar at ti.com>
> Acked-by: Benoit Cousson <b-cousson at ti.com>

Acked-by: Kevin Hilman <khilman at deeprootsystems.com>

> ---
>  arch/arm/mach-omap2/pm.c |    8 +++++---
>  1 files changed, 5 insertions(+), 3 deletions(-)
>
> diff --git a/arch/arm/mach-omap2/pm.c b/arch/arm/mach-omap2/pm.c
> index dc68044..a2a70e1 100644
> --- a/arch/arm/mach-omap2/pm.c
> +++ b/arch/arm/mach-omap2/pm.c
> @@ -91,8 +91,7 @@ static void omap2_init_processor_devices(void)
>  
>  /*
>   * This sets pwrdm state (other than mpu & core. Currently only ON &
> - * RET are supported. Function is assuming that clkdm doesn't have
> - * hw_sup mode enabled.
> + * RET are supported.
>   */
>  int omap_set_pwrdm_state(struct powerdomain *pwrdm, u32 state)
>  {
> @@ -135,7 +134,10 @@ int omap_set_pwrdm_state(struct powerdomain *pwrdm, u32 state)
>  	}
>  
>  	if (sleep_switch) {
> -		omap2_clkdm_allow_idle(pwrdm->pwrdm_clkdms[0]);
> +		if (pwrdm->pwrdm_clkdms[0]->flags & CLKDM_CAN_ENABLE_AUTO)
> +			omap2_clkdm_allow_idle(pwrdm->pwrdm_clkdms[0]);
> +		else
> +			omap2_clkdm_sleep(pwrdm->pwrdm_clkdms[0]);
>  		pwrdm_wait_transition(pwrdm);
>  		pwrdm_state_switch(pwrdm);
>  	}