[PATCH 9/9] ARM i.MX51 babbage: Add framebuffer support

[Sascha Hauer]

On Sun, Dec 12, 2010 at 09:37:38AM +0800, Liu Ying wrote:
> Hello, Sascha,
> 
> I have following 3 comments to this patch:
> 1) I think DISP1_DATx pins need not be set specially, as they keep the
> default register values.

We do not want to depend on default register values in the Linux Kernel.

> 2) Please define 'MX51_PAD_DI_GP4__IPU_DI2_PIN15' in
> arch/arm/plat-mxc/include/mach/iomux-mx51.h, and rename the pin to be
> 'MX51_PAD_DI_GP4__DI2_PIN15', as we name it according to the MX51
> iomux reference manual.

I'm not sure. Normally it's good practice to code the unit into the
name. Otherwise we end up with names like MX51_PAD_xyz__TX which could
be the tx pin of just about any unit.


> 3) It is better to exchange the following two lines or just remove the
> first line:
> +       gpio_set_value(GPIO_DVI_RESET, 0);
> +       gpio_direction_output(GPIO_DVI_RESET, 0);

ok.

Sascha


-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |