[PATCH 3/5] msm: timer: SMP timer support for msm
Thomas Gleixner
tglx at linutronix.de
Mon Dec 6 04:56:14 EST 2010
On Sun, 5 Dec 2010, Jeff Ohlstein wrote:
> +
> +static struct msm_clock msm_clocks[];
> +static struct clock_event_device *local_clock_event;
> +
> static irqreturn_t msm_timer_interrupt(int irq, void *dev_id)
> {
> struct clock_event_device *evt = dev_id;
> + if (smp_processor_id() != 0)
> + evt = local_clock_event;
Why is dev_id not pointing to the correct device in the first place?
> + if (evt->event_handler == NULL)
> + return IRQ_HANDLED;
> evt->event_handler(evt);
> return IRQ_HANDLED;
> }
>
> +static uint32_t msm_read_timer_count(struct msm_clock *clock,
> + enum timer_location global)
> +{
> + uint32_t t1;
> +
> + if (global)
> + t1 = readl(clock->regbase + TIMER_COUNT_VAL + MSM_TMR_GLOBAL);
> + else
> + t1 = readl(clock->regbase + TIMER_COUNT_VAL);
> +
> + return t1;
Adding such conditionals into a fast path is brilliant. Granted, gcc
might optimize it out, but I'm not sure given the number of call sites.
What's the point of this exercise ?
> +}
> +
> static cycle_t msm_gpt_read(struct clocksource *cs)
> {
> - return readl(MSM_GPT_BASE + TIMER_COUNT_VAL);
> + struct msm_clock *clock = &msm_clocks[MSM_CLOCK_GPT];
> + return msm_read_timer_count(clock, GLOBAL_TIMER);
Why don't you store the address of the read register including the
shift value into the msm_clock structure ?
clock->counter_reg
clock->counter_shift
And then embedd the clocksource struct there as well, so you can
dereference msm_clock with container_of() and reduce the 3 read
functions to a single one.
> }
>
> static cycle_t msm_dgt_read(struct clocksource *cs)
> {
> - return readl(MSM_DGT_BASE + TIMER_COUNT_VAL) >> MSM_DGT_SHIFT;
> + struct msm_clock *clock = &msm_clocks[MSM_CLOCK_DGT];
> +
> + return msm_read_timer_count(clock, GLOBAL_TIMER) >> MSM_DGT_SHIFT;
> +}
> +
> +static struct msm_clock *clockevent_to_clock(struct clock_event_device *evt)
> +{
> +#ifdef CONFIG_SMP
> + int i;
> + for (i = 0; i < NR_TIMERS; i++)
> + if (evt == &(msm_clocks[i].clockevent))
> + return &msm_clocks[i];
Why don't you use container_of here as well ?
> + return &msm_clocks[MSM_GLOBAL_TIMER];
> +#else
> + return container_of(evt, struct msm_clock, clockevent);
> +#endif
> }
>
> static int msm_timer_set_next_event(unsigned long cycles,
> struct clock_event_device *evt)
> {
> - struct msm_clock *clock = container_of(evt, struct msm_clock, clockevent);
> - uint32_t now = readl(clock->regbase + TIMER_COUNT_VAL);
> + struct msm_clock *clock = clockevent_to_clock(evt);
> + uint32_t now = msm_read_timer_count(clock, LOCAL_TIMER);
> uint32_t alarm = now + (cycles << clock->shift);
> int late;
>
> writel(alarm, clock->regbase + TIMER_MATCH_VAL);
> - now = readl(clock->regbase + TIMER_COUNT_VAL);
> +
> + now = msm_read_timer_count(clock, LOCAL_TIMER);
> late = now - alarm;
> if (late >= (-2 << clock->shift) && late < DGT_HZ*5) {
> - printk(KERN_NOTICE "msm_timer_set_next_event(%lu) clock %s, "
> - "alarm already expired, now %x, alarm %x, late %d\n",
> - cycles, clock->clockevent.name, now, alarm, late);
> + static int print_limit = 10;
> + if (print_limit > 0) {
> + print_limit--;
> + printk(KERN_NOTICE "msm_timer_set_next_event(%lu) "
> + "clock %s, alarm already expired, now %x, "
> + "alarm %x, late %d%s\n",
> + cycles, clock->clockevent.name, now, alarm, late,
> + print_limit ? "" : " stop printing");
> + }
The generic clockevents layer has already a check for this. No need
for extra printk spam.
> return -ETIME;
> }
> return 0;
> @@ -107,7 +171,11 @@ static int msm_timer_set_next_event(unsigned long cycles,
> static void msm_timer_set_mode(enum clock_event_mode mode,
> struct clock_event_device *evt)
> {
> - struct msm_clock *clock = container_of(evt, struct msm_clock, clockevent);
> + struct msm_clock *clock = clockevent_to_clock(evt);
> + unsigned long irq_flags;
> +
> + local_irq_save(irq_flags);
Always called with interrupts disabled.
> +
> switch (mode) {
> case CLOCK_EVT_MODE_RESUME:
> case CLOCK_EVT_MODE_PERIODIC:
> @@ -120,6 +188,7 @@ static void msm_timer_set_mode(enum clock_event_mode mode,
> writel(0, clock->regbase + TIMER_ENABLE);
> break;
> }
> + local_irq_restore(irq_flags);
> }
>
> static struct msm_clock msm_clocks[] = {
> @@ -220,6 +289,58 @@ static void __init msm_timer_init(void)
> }
> }
>
> +#ifdef CONFIG_SMP
> +void local_timer_setup(struct clock_event_device *evt)
> +{
> + unsigned long flags;
> + struct msm_clock *clock = &msm_clocks[MSM_GLOBAL_TIMER];
> +
> +#ifdef CONFIG_ARCH_MSM8X60
> + writel(DGT_CLK_CTL_DIV_4, MSM_TMR_BASE + DGT_CLK_CTL);
> +#endif
> +
> + if (!local_clock_event) {
> + writel(0, clock->regbase + TIMER_ENABLE);
> + writel(0, clock->regbase + TIMER_CLEAR);
> + writel(~0, clock->regbase + TIMER_MATCH_VAL);
> + }
> + evt->irq = clock->irq.irq;
> + evt->name = "local_timer";
> + evt->features = CLOCK_EVT_FEAT_ONESHOT;
> + evt->rating = clock->clockevent.rating;
> + evt->set_mode = msm_timer_set_mode;
> + evt->set_next_event = msm_timer_set_next_event;
> + evt->shift = clock->clockevent.shift;
> + evt->mult = div_sc(clock->freq, NSEC_PER_SEC, evt->shift);
> + evt->max_delta_ns =
> + clockevent_delta2ns(0xf0000000 >> clock->shift, evt);
> + evt->min_delta_ns = clockevent_delta2ns(4, evt);
> + evt->cpumask = cpumask_of(smp_processor_id());
> +
> + local_clock_event = evt;
> +
> + local_irq_save(flags);
> + get_irq_chip(clock->irq.irq)->unmask(clock->irq.irq);
Why are you fiddling wiht the irqchip functions directly ? Please use
disable_irq/enable_irq if at all.
> + local_irq_restore(flags);
> +
> + clockevents_register_device(evt);
> +}
> +
> +int local_timer_ack(void)
> +{
> + return 1;
Shouldn't that be an inline ? Why calling code which the compiler
could optimize out.
> +}
> +
> +#ifdef CONFIG_HOTPLUG_CPU
> +void __cpuexit local_timer_stop(void)
> +{
> + local_clock_event->set_mode(CLOCK_EVT_MODE_SHUTDOWN, local_clock_event);
Aarg. No. The generic code already handles cpu hotplug.
Thanks,
tglx
More information about the linux-arm-kernel
mailing list