[PATCH 1/3] irqchip/meson-gpio: fix incorrect register address

[Xianwei Zhao via B4 Relay]

From: Xianwei Zhao <xianwei.zhao at amlogic.com>

When set gpio irq type(level and single-edge) for S4, register address is
REG_EDGE_POL, not both-edge trigger register. This patch fix it.

Fixes: bbd6fcc76b39 ("irqchip: Add support for Amlogic A4 and A5 SoCs")
Signed-off-by: Xianwei Zhao <xianwei.zhao at amlogic.com>
---
 drivers/irqchip/irq-meson-gpio.c | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/drivers/irqchip/irq-meson-gpio.c b/drivers/irqchip/irq-meson-gpio.c
index f722e9c57e2e..74a376ef452e 100644
--- a/drivers/irqchip/irq-meson-gpio.c
+++ b/drivers/irqchip/irq-meson-gpio.c
@@ -415,8 +415,7 @@ static int meson_s4_gpio_irq_set_type(struct meson_gpio_irq_controller *ctl,
 	if (type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING))
 		val |= BIT(ctl->params->edge_single_offset + idx);
 
-	meson_gpio_irq_update_bits(ctl, params->edge_pol_reg,
-				   BIT(idx) | BIT(12 + idx), val);
+	meson_gpio_irq_update_bits(ctl, REG_EDGE_POL, BIT(idx) | BIT(12 + idx), val);
 	return 0;
 };
 

-- 
2.52.0