[PATCH RFC v2 02/11] ASoC: meson: aiu-encoder-i2s: use gx_iface and gx_stream structures

[Valerio Setti]

On 4/15/26 16:28, Jerome Brunet wrote:

> 
> Huh interresting, I had not thought of that. Valerio and I discussed the
> clock part a lot for this rework. It is the crux since since the
> interface and clock setting lives in the AIU subsys but serves both the
> AIU and AUDIN subsys.
> 
> Valerio maybe you could keep function above just to set the rate, but
> enabling the clocks through a DAPM supply widget ? This is kind of what
> the AXG is doing.
> 
> what do you think ?
> 
> (actually in the AXG the each formatter widget call CCF
> clk_prepare_enable() but a supply widget poking the register would do
> the same thing)
> 

Hi Jerome,

thanks for your review and suggestion.
I took some time to investigate it and I think I have a different 
proposal that reduces the amount of changes compared to the current 
implementation, but gets to the same result.

The thing is in "axg-tdm-interface.c" MCLK is enabled/disabled using 
"set_bias_level()" callback which works fine because in that case the 
interface driver is also a standalone component. On the GX platform the 
interface is a DAI which is part of the AIU component, so this callback 
isn't available. To get the same behavior I would need to add a new DAPM 
widget in "aiu_cpu_dapm_widgets[]" and then add it to both 
"aiu_cpu_dapm_routes[]" both in "aiu.c" and in the device-tree for AUDIN.

What if instead I add the "prepare()" callback to 
"aiu_encoder_i2s_dai_ops" and enable MCLK and I2S clock divider there? 
This would match "hw_free()" calls and it would be a change only 
internal to "aiu-encoder-i2s.c".
To support this I will:
- remove calls to "gx_stream_set_cont_clocks" which are arguably not 
very useful for the GX platform;
- use the "clk_enabled" field of "struct gx_stream" (unused after 
removal of "gx_stream_set_cont_clocks" calls) to track the status of 
MCLK and enable/disable it only when necessary (ex: prevent multiple 
calls to "prepare" to enable MCLK multiple times, etc);
- keep using "snd_soc_dai_active" in "hw_free" to know when to disable 
the I2S clock divider. Or perhaps I can rely on "clk_enabled" also for 
this one so that I can manage these 2 clocks uniformly.

Is this an acceptable alternative approach for you?

-- 
Valerio