[PATCH] arm64: dts: amlogic: add support for Amedia X98Q

[Ferass El Hafidi]

On Sun, 19 Apr 2026 15:08, christian.koever-draxl at student.uibk.ac.at wrote:
>From: Christian Stefan Kövér-Draxl <christian.koever-draxl at student.uibk.ac.at>
>
>The X98Q is a TV box based on the Amlogic S4 (S905W2) SoC.
>Add the device tree for this board and document the compatible string.
>
>Supported features:
>- 1GB/2GB RAM (via U-Boot memory fixup)
>- 10/100 Ethernet (Internal PHY)
>- eMMC and SD card storage
>- PWM-based CPU voltage regulation
>- UART (Serial console)
>
>Signed-off-by: Christian Stefan Kövér-Draxl <christian.koever-draxl at student.uibk.ac.at>
>---
>- The Wi-Fi chip on this board is Amlogic W150S1. I have left the SDIO node enabled
>  but omitted the specific chip sub-node due to lack of mainline drivers (yet).
>- The console uses uart_b at 921600 baud.
>- Verified memory via /proc/device-tree; U-Boot patches the node to around 2GB if board supports more than 1GB.
>- Tested on the 2GB RAM plus 16GB EMMC variant.
>

Also, I just noticed now, but you seem to be missing a lot of people in
your To/Cc. You should use get_maintainer.pl to get the list of
the people you should send your patch to.

(you can also use b4 (v0.14 is what I use) to make sending patches
properly much easier)

--
Best regards,
Ferass