[PATCH v2 1/5] arm64: dts: meson: bananapi-m5: switch VDDIO_C pin to OPEN_DRAIN

Neil Armstrong neil.armstrong at linaro.org
Fri Jan 27 08:23:44 PST 2023


On 27/01/2023 15:22, Christian Hewitt wrote:
> For proper warm (re)boot from SD card the BPI-M5 board requires TFLASH_VDD_EN
> and VDDIO_C pins to be switched to high impedance mode. This can be achieved
> using OPEN_DRAIN instead of ACTIVE_HIGH to leave the GPIO pins in input mode
> and retain high state (pin has the pull-up).
> 
> This change is inspired by meson-sm1-odroid.dtsi where OPEN_DRAIN has been
> used to resolve similar problems with the Odroid C4 board (TF_IO in the C4
> dts is the equivalent regulator).
> 
> Fixes: 976e920183e4 ("arm64: dts: meson-sm1: add Banana PI BPI-M5 board dts")
> Suggested-by: Neil Armstrong <neil.armstrong at linaro.org>
> Signed-off-by: Christian Hewitt <christianshewitt at gmail.com>
> ---
>   arch/arm64/boot/dts/amlogic/meson-sm1-bananapi-m5.dts | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/amlogic/meson-sm1-bananapi-m5.dts b/arch/arm64/boot/dts/amlogic/meson-sm1-bananapi-m5.dts
> index 028220ed45ad..3c1267a7ffef 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-sm1-bananapi-m5.dts
> +++ b/arch/arm64/boot/dts/amlogic/meson-sm1-bananapi-m5.dts
> @@ -123,7 +123,7 @@ vddio_c: regulator-vddio_c {
>   		regulator-min-microvolt = <1800000>;
>   		regulator-max-microvolt = <3300000>;
>   
> -		enable-gpio = <&gpio_ao GPIOE_2 GPIO_ACTIVE_HIGH>;
> +		enable-gpio = <&gpio_ao GPIOE_2 GPIO_OPEN_DRAIN>;
>   		enable-active-high;
>   		regulator-always-on;
>   

Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>



More information about the linux-amlogic mailing list