[PATCH RESEND linux-next v4.1 0/4] Used onboard HUB to reset and add power to hub

[Anand Moon]

Amlogic board use gpio-hog to reset the USB hub.
so using onboard hub we could reset the USB hub and
also enable power to the USB hub.

v4: rebased on linux-next
    Fixed some small changes like the subject.
    Dropped the merge patches.

v3: Fix some small changes in $subject
    address the input from Neil
    fix the vialab device tree binding as per Krzysztof inputs.

[2] https://lore.kernel.org/all/20230121175639.12818-2-linux.amoon@gmail.com

v2: Odroid C1 / C2 : usb hub reset working as expected.
    Odroid N2 : dropped usb hub changes, since my board USB hub
                is hitting regression.
    Odroid C4 : Fix the device tree binding and used peer-hub for
                usb2.0 and usb3.0 hub.
[1] https://lore.kernel.org/all/20230118044418.875-10-linux.amoon@gmail.com

v1: Odroid C1 / C2 : were not working as expected.
    Odroid N2 : used single USB 3.0 hub reset.
    Odroid C4 : used single USB 3.0 hub reset.

[0] https://patchwork.kernel.org/project/linux-amlogic/list/?series=707292

Any inputs for these changes ?

Thanks
-Anand

Anand Moon (4):
  ARM: dts: amlogic: Drop superfluous dr_mode in usb node on odroid C1
  arm64: dts: amlogic: Drop superfluous dr_mode in usb node on odroid c2
  arm64: dts: meson: move usb-hub node under dwc3 node on Odroid C4
  dt-bindings: usb: Fix properties for VL817 hub controller

 .../devicetree/bindings/usb/vialab,vl817.yaml | 18 ++++----
 arch/arm/boot/dts/meson8b-odroidc1.dts        |  1 -
 .../boot/dts/amlogic/meson-gxbb-odroidc2.dts  |  1 -
 .../boot/dts/amlogic/meson-sm1-odroid-c4.dts  | 41 +++++++++----------
 4 files changed, 30 insertions(+), 31 deletions(-)

-- 
2.38.1