[PATCH 10/13] dt-bindings: serial: st,stm32-uart: drop common properties

[Krzysztof Kozlowski]

The binding references serial and rs485 schemas, so there is no need to
list their properties.  Simplify a bit by removing unneeded entries.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
---
 .../devicetree/bindings/serial/st,stm32-uart.yaml          | 7 -------
 1 file changed, 7 deletions(-)

diff --git a/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml b/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
index 85876c668f6d..1df8ffe95fc6 100644
--- a/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
+++ b/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
@@ -35,8 +35,6 @@ properties:
     description: enable hardware flow control (deprecated)
     $ref: /schemas/types.yaml#/definitions/flag
 
-  uart-has-rtscts: true
-
   rx-tx-swap: true
 
   dmas:
@@ -60,11 +58,6 @@ properties:
 
   wakeup-source: true
 
-  rs485-rts-delay: true
-  rs485-rts-active-low: true
-  linux,rs485-enabled-at-boot-time: true
-  rs485-rx-during-tx: true
-
   rx-threshold:
     description:
       If value is set to 1, RX FIFO threshold is disabled.
-- 
2.34.1