[PATCH 07/13] dt-bindings: serial: fsl-imx-uart: drop common properties

[Krzysztof Kozlowski]

The binding references serial and rs485 schemas, so there is no need to
list their properties.  Simplify a bit by removing unneeded entries.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
---
 Documentation/devicetree/bindings/serial/fsl-imx-uart.yaml | 7 -------
 1 file changed, 7 deletions(-)

diff --git a/Documentation/devicetree/bindings/serial/fsl-imx-uart.yaml b/Documentation/devicetree/bindings/serial/fsl-imx-uart.yaml
index 9d949296a142..b431a0d1cd6b 100644
--- a/Documentation/devicetree/bindings/serial/fsl-imx-uart.yaml
+++ b/Documentation/devicetree/bindings/serial/fsl-imx-uart.yaml
@@ -83,13 +83,6 @@ properties:
       are sensible for most use cases. If you need low latency processing on
       slow connections this needs to be configured appropriately.
 
-  uart-has-rtscts: true
-
-  rs485-rts-delay: true
-  rs485-rts-active-low: true
-  rs485-rx-during-tx: true
-  linux,rs485-enabled-at-boot-time: true
-
 required:
   - compatible
   - reg
-- 
2.34.1