[PATCH v2 2/9] ARM: dts: amlogic: Used onboard usb hub reset to enable usb hub

[Neil Armstrong]

On 18/01/2023 05:44, Anand Moon wrote:
> On Odroid c1 previously use gpio-hog to reset the usb hub,
> switch to used on board usb hub reset to enable the usb hub
> and enable power to usb hub.
> 
> Add usb hub regulator as per the schematic.
> 
> Signed-off-by: Anand Moon <linux.amoon at gmail.com>
> ---
> v2 - drop the vendor name from compatible string.
>     - move the hub node to USB controller node.
>     - drop the usb_otg_pwr since it only liked to OTG port
>       and link p5v0 to the vdd-supply.
> ---
>   arch/arm/boot/dts/meson8b-odroidc1.dts | 24 +++++++++++-------------
>   1 file changed, 11 insertions(+), 13 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts
> index 04356bc639fa..d1f9ce4742a8 100644
> --- a/arch/arm/boot/dts/meson8b-odroidc1.dts
> +++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
> @@ -281,19 +281,6 @@ &gpio_ao {
>   			  "J7 Header Pin 6", "J7 Header Pin 5",
>   			  "J7 Header Pin 7", "HDMI_CEC",
>   			  "SYS_LED", "", "";
> -
> -	/*
> -	 * WARNING: The USB Hub on the Odroid-C1/C1+ needs a reset signal
> -	 * to be turned high in order to be detected by the USB Controller.
> -	 * This signal should be handled by a USB specific power sequence
> -	 * in order to reset the Hub when USB bus is powered down.
> -	 */
> -	usb-hub {
> -		gpio-hog;
> -		gpios = <GPIOAO_4 GPIO_ACTIVE_HIGH>;
> -		output-high;
> -		line-name = "usb-hub-reset";
> -	};
>   };
>   
>   &ir_receiver {
> @@ -381,5 +368,16 @@ &usb1_phy {
>   };
>   
>   &usb1 {
> +	dr_mode = "host";
> +	#address-cells = <1>;
> +	#size-cells = <0>;
>   	status = "okay";
> +
> +	hub at 1 {
> +		/* Genesys Logic GL852G usb hub */
> +		compatible = "usb5e3,610";
> +		reg = <1>;
> +		vdd-supply = <&p5v0>;
> +		reset-gpio = <&gpio_ao GPIOAO_4 GPIO_ACTIVE_LOW>;
> +	};
>   };

Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>