[PATCH v2 0/9] Used onboard HUB to reset and add power to hub

[Anand Moon]

Amlogic board use gpio-hog to reset the USB hub.
so using onboard hub we could reset the USB hub and
also enable power to the USB hub.

v2: Odroid C1 / C2 : usb hub reset working as expected.
    Odroid N2 : dropped usb hub changes, since my board USB hub
		is hitting regression.
    Odroid C4 : Fix the device tree binding and used peer-hub for
		usb2.0 and usb3.0 hub.

v1: Odroid C1 / C2 : were not working as expected.
    Odroid N2 : used single USB 3.0 hub reset.
    Odroid C4 : used single USB 3.0 hub reset.

[0] https://patchwork.kernel.org/project/linux-amlogic/list/?series=707292

Any inputs for these changes ?

Thanks
-Anand

Anand Moon (9):
  dt-bindings: usb: Add device id for Genesys Logic hub controller
  ARM: dts: amlogic: Used onboard usb hub reset to enable usb hub
  arm64: dts: amlogic: Used onboard usb hub reset on odroid c2
  usb: misc: onboard_usb_hub: add Genesys Logic GL852G hub support
  vendor-prefixes: Add VIA Labs, Inc.
  dt-bindings: usb: Add binding for Via lab VL817 hub controller
  arm64: dts: amlogic: Used onboard usb hub reset on odroid c4
  usb: misc: onboard_usb_hub: add VIA LAB VL817 hub support
  arm64: defconfig: Enable USB onboard HUB driver

 .../bindings/usb/genesys,gl850g.yaml          |  1 +
 .../devicetree/bindings/usb/vialab,vl817.yaml | 69 +++++++++++++++++++
 .../devicetree/bindings/vendor-prefixes.yaml  |  2 +
 arch/arm/boot/dts/meson8b-odroidc1.dts        | 24 +++----
 .../boot/dts/amlogic/meson-gxbb-odroidc2.dts  | 26 +++----
 .../boot/dts/amlogic/meson-sm1-odroid-c4.dts  | 36 ++++++----
 arch/arm64/configs/defconfig                  |  1 +
 drivers/usb/misc/onboard_usb_hub.c            |  4 ++
 drivers/usb/misc/onboard_usb_hub.h            | 11 +++
 9 files changed, 133 insertions(+), 41 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/usb/vialab,vl817.yaml

-- 
2.38.1