[PATCH] mtd: rawnand: meson: fix the clock after discarding sd_emmc_c_clkc
Miquel Raynal
miquel.raynal at bootlin.com
Thu Jan 6 00:08:32 PST 2022
Hi Liang,
liang.yang at amlogic.com wrote on Thu, 6 Jan 2022 11:25:04 +0800:
> Because EMMC and NAND have the same control clock register, so we
> implement a 'sd_emmc_c_clkc'. Previously DTS is defined as below:
>
> sd_emmc_c_clkc: mmc at 7000 {
> compatible = "amlogic,meson-axg-mmc-clkc", "syscon";
> reg = <0x0 0x7000 0x0 0x800>;
> };
>
> nand-controller at 7800 {
> ......
>
> clocks = <&clkc CLKID_SD_EMMC_C>,
> <&sd_emmc_c_clkc CLKID_MMC_DIV>,
> <&sd_emmc_c_clkc CLKID_MMC_PHASE_RX>,
> <&sd_emmc_c_clkc CLKID_MMC_PHASE_TX>;
> clock-names = "core", "device", "rx", "tx";
> amlogic,mmc-syscon = <&sd_emmc_c_clkc>;
>
> ......
> }
>
> but in fact, above implementation is rejected. so now registering
> a nand_divider.
What is rejected?
Why is it rejected?
What is nand_divider?
>
> Change-Id: Ibeb4c7ff886f5886aac4d6c664d7bbd1b1bcb997
Change Ids are not expected in the upstream kernel.
But if you fix something you should have a Fixes:.
> Signed-off-by: Liang Yang <liang.yang at amlogic.com>
> ---
> drivers/mtd/nand/raw/meson_nand.c | 88 +++++++++++++++++--------------
> 1 file changed, 49 insertions(+), 39 deletions(-)
>
> diff --git a/drivers/mtd/nand/raw/meson_nand.c b/drivers/mtd/nand/raw/meson_nand.c
> index ac3be92872d0..4472363059c2 100644
> --- a/drivers/mtd/nand/raw/meson_nand.c
> +++ b/drivers/mtd/nand/raw/meson_nand.c
> @@ -2,7 +2,7 @@
> /*
> * Amlogic Meson Nand Flash Controller Driver
> *
> - * Copyright (c) 2018 Amlogic, inc.
> + * Copyright (c) 2018-2021 Amlogic, inc.
> * Author: Liang Yang <liang.yang at amlogic.com>
> */
>
> @@ -10,6 +10,7 @@
> #include <linux/dma-mapping.h>
> #include <linux/interrupt.h>
> #include <linux/clk.h>
> +#include <linux/clk-provider.h>
> #include <linux/mtd/rawnand.h>
> #include <linux/mtd/mtd.h>
> #include <linux/mfd/syscon.h>
> @@ -55,6 +56,7 @@
> #define NFC_REG_VER 0x38
>
> #define NFC_RB_IRQ_EN BIT(21)
> +#define NFC_CMD_FIFO_RESET BIT(31)
>
> #define CMDRWGEN(cmd_dir, ran, bch, short_mode, page_size, pages) \
> ( \
> @@ -104,6 +106,9 @@
>
> #define PER_INFO_BYTE 8
>
> +#define CLK_DIV_SHIFT 0
> +#define CLK_DIV_WIDTH 6
> +
> struct meson_nfc_nand_chip {
> struct list_head node;
> struct nand_chip nand;
> @@ -151,15 +156,15 @@ struct meson_nfc {
> struct nand_controller controller;
> struct clk *core_clk;
> struct clk *device_clk;
> - struct clk *phase_tx;
> - struct clk *phase_rx;
> + struct clk *nand_clk;
> + struct clk_divider nand_divider;
>
> unsigned long clk_rate;
> u32 bus_timing;
>
> struct device *dev;
> void __iomem *reg_base;
> - struct regmap *reg_clk;
> + void __iomem *reg_clk;
> struct completion completion;
> struct list_head chips;
> const struct meson_nfc_data *data;
> @@ -406,12 +411,14 @@ static int meson_nfc_queue_rb(struct meson_nfc *nfc, int timeout_ms)
> cmd = NFC_CMD_RB | NFC_CMD_RB_INT
> | nfc->param.chip_select | nfc->timing.tbers_max;
> writel(cmd, nfc->reg_base + NFC_REG_CMD);
> -
> + meson_nfc_drain_cmd(nfc);
> ret = wait_for_completion_timeout(&nfc->completion,
> msecs_to_jiffies(timeout_ms));
> if (ret == 0)
> ret = -1;
>
> + /* reset command fifo to avoid lock */
> + writel(NFC_CMD_FIFO_RESET, nfc->reg_base + NFC_REG_CMD);
> return ret;
> }
>
> @@ -988,8 +995,9 @@ static const struct mtd_ooblayout_ops meson_ooblayout_ops = {
> static int meson_nfc_clk_init(struct meson_nfc *nfc)
> {
> int ret;
> + struct clk_init_data init = {0};
> + const char *fix_div2_pll_name[1];
>
> - /* request core clock */
> nfc->core_clk = devm_clk_get(nfc->dev, "core");
> if (IS_ERR(nfc->core_clk)) {
> dev_err(nfc->dev, "failed to get core clock\n");
> @@ -1002,21 +1010,25 @@ static int meson_nfc_clk_init(struct meson_nfc *nfc)
> return PTR_ERR(nfc->device_clk);
> }
>
> - nfc->phase_tx = devm_clk_get(nfc->dev, "tx");
> - if (IS_ERR(nfc->phase_tx)) {
> - dev_err(nfc->dev, "failed to get TX clk\n");
> - return PTR_ERR(nfc->phase_tx);
> - }
> -
> - nfc->phase_rx = devm_clk_get(nfc->dev, "rx");
> - if (IS_ERR(nfc->phase_rx)) {
> - dev_err(nfc->dev, "failed to get RX clk\n");
> - return PTR_ERR(nfc->phase_rx);
> - }
> + init.name = devm_kstrdup(nfc->dev, "nfc#div", GFP_KERNEL);
> + init.ops = &clk_divider_ops;
> + fix_div2_pll_name[0] = __clk_get_name(nfc->device_clk);
> + init.parent_names = fix_div2_pll_name;
> + init.num_parents = 1;
> + nfc->nand_divider.reg = nfc->reg_clk;
> + nfc->nand_divider.shift = CLK_DIV_SHIFT;
> + nfc->nand_divider.width = CLK_DIV_WIDTH;
> + nfc->nand_divider.hw.init = &init;
> + nfc->nand_divider.flags = CLK_DIVIDER_ONE_BASED |
> + CLK_DIVIDER_ROUND_CLOSEST |
> + CLK_DIVIDER_ALLOW_ZERO;
> +
> + nfc->nand_clk = devm_clk_register(nfc->dev, &nfc->nand_divider.hw);
> + if (IS_ERR(nfc->nand_clk))
> + return PTR_ERR(nfc->nand_clk);
>
> /* init SD_EMMC_CLOCK to sane defaults w/min clock rate */
> - regmap_update_bits(nfc->reg_clk,
> - 0, CLK_SELECT_NAND, CLK_SELECT_NAND);
> + writel(CLK_SELECT_NAND | readl(nfc->reg_clk), nfc->reg_clk);
>
> ret = clk_prepare_enable(nfc->core_clk);
> if (ret) {
> @@ -1030,29 +1042,21 @@ static int meson_nfc_clk_init(struct meson_nfc *nfc)
> goto err_device_clk;
> }
>
> - ret = clk_prepare_enable(nfc->phase_tx);
> + ret = clk_prepare_enable(nfc->nand_clk);
> if (ret) {
> - dev_err(nfc->dev, "failed to enable TX clock\n");
> - goto err_phase_tx;
> - }
> -
> - ret = clk_prepare_enable(nfc->phase_rx);
> - if (ret) {
> - dev_err(nfc->dev, "failed to enable RX clock\n");
> - goto err_phase_rx;
> + dev_err(nfc->dev, "pre enable NFC divider fail\n");
> + goto err_nand_clk;
> }
>
> ret = clk_set_rate(nfc->device_clk, 24000000);
> if (ret)
> - goto err_disable_rx;
> + goto err_disable_clk;
>
> return 0;
>
> -err_disable_rx:
> - clk_disable_unprepare(nfc->phase_rx);
> -err_phase_rx:
> - clk_disable_unprepare(nfc->phase_tx);
> -err_phase_tx:
> +err_disable_clk:
> + clk_disable_unprepare(nfc->nand_clk);
> +err_nand_clk:
> clk_disable_unprepare(nfc->device_clk);
> err_device_clk:
> clk_disable_unprepare(nfc->core_clk);
> @@ -1061,8 +1065,7 @@ static int meson_nfc_clk_init(struct meson_nfc *nfc)
>
> static void meson_nfc_disable_clk(struct meson_nfc *nfc)
> {
> - clk_disable_unprepare(nfc->phase_rx);
> - clk_disable_unprepare(nfc->phase_tx);
> + clk_disable_unprepare(nfc->nand_clk);
> clk_disable_unprepare(nfc->device_clk);
> clk_disable_unprepare(nfc->core_clk);
> }
> @@ -1375,6 +1378,7 @@ static int meson_nfc_probe(struct platform_device *pdev)
> struct device *dev = &pdev->dev;
> struct meson_nfc *nfc;
> struct resource *res;
> + u32 ext_clk_reg;
> int ret, irq;
>
> nfc = devm_kzalloc(dev, sizeof(*nfc), GFP_KERNEL);
> @@ -1396,9 +1400,15 @@ static int meson_nfc_probe(struct platform_device *pdev)
> if (IS_ERR(nfc->reg_base))
> return PTR_ERR(nfc->reg_base);
>
> - nfc->reg_clk =
> - syscon_regmap_lookup_by_phandle(dev->of_node,
> - "amlogic,mmc-syscon");
> + ret = of_property_read_u32(pdev->dev.of_node,
> + "sd_emmc_c_clkc",
> + &ext_clk_reg);
> + if (ret) {
> + dev_err(dev, "failed to get NAND external clock register\n");
> + return ret;
> + }
> +
> + nfc->reg_clk = devm_ioremap(&pdev->dev, ext_clk_reg, sizeof(int));
> if (IS_ERR(nfc->reg_clk)) {
> dev_err(dev, "Failed to lookup clock base\n");
> return PTR_ERR(nfc->reg_clk);
Thanks,
Miquèl
More information about the linux-amlogic
mailing list