[PATCH V2 1/2] tty: serial: meson: Add a 12MHz internal clock rate to calculate baud rate in order to meet the baud rate requirements of special BT modules

Yu Tu yu.tu at amlogic.com
Tue Apr 19 00:29:19 PDT 2022


Hi Andy,
	Thank you for your advice.

On 2022/4/18 20:09, Andy Shevchenko wrote:
> [ EXTERNAL EMAIL ]
> 
> On Mon, Apr 18, 2022 at 8:50 AM Yu Tu <yu.tu at amlogic.com> wrote:
>>
>> A /2 divider over XTAL was introduced since G12A, and is preferred
>> to be used over the still present /3 divider since it provides much
>> closer frequencies vs the request baudrate.Especially the BT module
> 
> 'e. E' (mind the space)
My statement is a whole. There should be no spaces.
> 
>> uses 3Mhz baud rate. 8Mhz calculations can lead to baud rate bias,
>> causing some problems.
> 
> ...
> 
>> +struct meson_uart_data {
>> +       bool has_xtal_div2;
> 
> I would prefer to see this as an unsigned int and with a less
> particular name, e.g. xtal_div would suffice.
I don't have a problem with your suggestion.Let's see What Neil has to say.
> 
>> +};
> 
> ...
> 
>> +               unsigned int xtal_div = 3;
> 
>> +               if (private_data && private_data->has_xtal_div2) {
>> +                       xtal_div = 2;
> 
> Better to define privata data always
> 
> 
>> +                       val |= AML_UART_BAUD_XTAL_DIV2;
>> +               }
>> +               val |= DIV_ROUND_CLOSEST(port->uartclk / xtal_div, baud) - 1;
> 
> 



More information about the linux-amlogic mailing list