[PATCH 0/2] drm/bridge: dw-hdmi: disable loading of DW-HDMI CEC sub-driver

Neil Armstrong narmstrong at baylibre.com
Fri Apr 16 12:38:59 BST 2021


On 16/04/2021 11:58, Laurent Pinchart wrote:
> Hi Neil,
> 
> On Fri, Apr 16, 2021 at 11:27:35AM +0200, Neil Armstrong wrote:
>> This adds DW-HDMI driver a glue option to disable loading of the CEC sub-driver.
>>
>> On some SoCs, the CEC functionality is enabled in the IP config bits, but the
>> CEC bus is non-functional like on Amlogic SoCs, where the CEC config bit is set
>> but the DW-HDMI CEC signal is not connected to a physical pin, leading to some
>> confusion when the DW-HDMI CEC controller can't communicate on the bus.
> 
> If we can't trust the CEC config bit, would it be better to not use it
> at all, and instead let each platform glue logic tell whether to enable
> CEC or not ?

Actually, the CEC config bit is right, the HW exists and should be functional, but
this bit doesn't tell if the CEC signal is connected to something.

This lies in the IP integration, like other bits under the "amlogic,meson-*-dw-hdmi"
umbrella.

The first attempt was by Hans using DT, but adding a property in DT for a vendor
specific compatible doesn't make sense. Another idea would be to describe the
CEC signal endpoint like we do for video signal, but I think this is out of scope and
this solution is much simpler and straightforward, and it's more an exception than
a general use case to solve.

Neil

> 
>> Jernej Skrabec (1):
>>   drm/bridge/synopsys: dw-hdmi: Add an option to suppress loading CEC
>>     driver
>>
>> Neil Armstrong (1):
>>   drm/meson: dw-hdmi: disable DW-HDMI CEC sub-driver
>>
>>  drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 2 +-
>>  drivers/gpu/drm/meson/meson_dw_hdmi.c     | 1 +
>>  include/drm/bridge/dw_hdmi.h              | 2 ++
>>  3 files changed, 4 insertions(+), 1 deletion(-)
>>
> 




More information about the linux-amlogic mailing list