[PATCH] ARM: dts: meson8b-odroidc1: add microSD support
Linus Lüssing
linus.luessing at c0d3.blue
Sat Mar 17 13:11:14 PDT 2018
The Odroid C1 features a microSD slot. This patch adds the necessary
DT bindings to support it.
Signed-off-by: Linus Lüssing <linus.luessing at c0d3.blue>
---
Should probably be applied only after:
"[PATCH v3 1/1] ARM: dts: meson8b: the CBUS GPIO controller only has 83 GPIOs"
-> https://patchwork.kernel.org/patch/10277473/
Changes since "RFC":
- none
But retested with the following patches on top of 4.16-rc5:
- "[PATCH v2 1/2] pinctrl: meson: meson8b: fix requesting GPIOs greater than GPIOZ_3"
-> https://patchwork.kernel.org/patch/10240807/
- "[PATCH v3 1/1] ARM: dts: meson8b: the CBUS GPIO controller only has 83 GPIOs"
-> https://patchwork.kernel.org/patch/10277473/
arch/arm/boot/dts/meson8b-odroidc1.dts | 58 ++++++++++++++++++++++++++++++++++
arch/arm/boot/dts/meson8b.dtsi | 8 +++++
2 files changed, 66 insertions(+)
diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts
index d5e83051bb54..3a5603d95b70 100644
--- a/arch/arm/boot/dts/meson8b-odroidc1.dts
+++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
@@ -54,6 +54,7 @@
aliases {
serial0 = &uart_AO;
+ mmc0 = &sd_card_slot;
};
memory {
@@ -69,6 +70,37 @@
default-state = "off";
};
};
+
+ tflash_vdd: regulator-tflash_vdd {
+ /*
+ * signal name from schematics: TFLASH_VDD_EN
+ */
+ compatible = "regulator-fixed";
+
+ regulator-name = "TFLASH_VDD";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+
+ gpio = <&gpio GPIOY_12 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ };
+
+ tf_io: gpio-regulator-tf_io {
+ compatible = "regulator-gpio";
+
+ regulator-name = "TF_IO";
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <3300000>;
+
+ /*
+ * signal name from schematics: TF_3V3N_1V8_EN
+ */
+ gpios = <&gpio_ao GPIOAO_3 GPIO_ACTIVE_HIGH>;
+ gpios-states = <0>;
+
+ states = <3300000 0
+ 1800000 1>;
+ };
};
&uart_AO {
@@ -100,6 +132,32 @@
status = "okay";
};
+&sdio {
+ status = "okay";
+
+ pinctrl-0 = <&sd_b_pins>;
+ pinctrl-names = "default";
+
+ /* SD card */
+ sd_card_slot: slot at 1 {
+ compatible = "mmc-slot";
+ reg = <1>;
+ status = "okay";
+
+ bus-width = <4>;
+ no-sdio;
+ cap-mmc-highspeed;
+ cap-sd-highspeed;
+ disable-wp;
+
+ cd-gpios = <&gpio CARD_6 GPIO_ACTIVE_HIGH>;
+ cd-inverted;
+
+ vmmc-supply = <&tflash_vdd>;
+ vqmmc-supply = <&tf_io>;
+ };
+};
+
ðmac {
status = "okay";
diff --git a/arch/arm/boot/dts/meson8b.dtsi b/arch/arm/boot/dts/meson8b.dtsi
index 202c2b8c79b8..92e240d08fb2 100644
--- a/arch/arm/boot/dts/meson8b.dtsi
+++ b/arch/arm/boot/dts/meson8b.dtsi
@@ -206,6 +206,14 @@
function = "ethernet";
};
};
+
+ sd_b_pins: sd-b {
+ mux {
+ groups = "sd_d0_b", "sd_d1_b", "sd_d2_b",
+ "sd_d3_b", "sd_clk_b", "sd_cmd_b";
+ function = "sd_b";
+ };
+ };
};
};
--
2.11.0
More information about the linux-amlogic
mailing list