[PATCH 03/18] mmc: meson-gx: explicitely call stop command for multi-block commands only

[Heiner Kallweit]

Explicitely call stop command for multi-block commands only.

Signed-off-by: Heiner Kallweit <hkallweit1 at gmail.com>
---
 drivers/mmc/host/meson-gx-mmc.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/mmc/host/meson-gx-mmc.c b/drivers/mmc/host/meson-gx-mmc.c
index e89bdf5f..ece38b44 100644
--- a/drivers/mmc/host/meson-gx-mmc.c
+++ b/drivers/mmc/host/meson-gx-mmc.c
@@ -686,10 +686,10 @@ static irqreturn_t meson_mmc_irq_thread(int irq, void *dev_id)
 	}
 
 	meson_mmc_read_resp(host->mmc, cmd);
-	if (!data || !data->stop)
-		meson_mmc_request_done(host->mmc, mrq);
-	else
+	if (mmc_op_multi(cmd->opcode))
 		meson_mmc_start_cmd(host->mmc, data->stop);
+	else
+		meson_mmc_request_done(host->mmc, mrq);
 
 	return IRQ_HANDLED;
 }
-- 
2.11.1