[PATCH v2 0/3] eMMC, SD-card and ethernet support for Vega S95 boards

[Kevin Hilman]

On Wed, Sep 7, 2016 at 1:06 PM, Kevin Hilman <khilman at baylibre.com> wrote:
> Hi Marrtin,
>
> Martin Blumenstingl <martin.blumenstingl at googlemail.com> writes:
>
>> This adds support for the internal eMMC, the SD-card slot and ethernet on
>> all Tronsmart S95 Vega boards.
>> There are some S95 Vega Meta clones out there where the bootloader does
>> not configure the ethernet registers correctly, leading to non-working
>> ethernet. This will be fixed in a separate series. Boards which are not
>> suffering from broken bootloaders have fully working ethernet.
>>
>> Changes since v1:
>> - rebased after latest updates which added the IR decoder to
>>   meson-gxbb-vega-s95.dtsi
>>
>> Changes since the RFC:
>> - added eMMC support
>> - renamed fixed 3V3 regulator so it can be re-used for eMMC
>>
>>
>> Martin Blumenstingl (3):
>>   ARM64: dts: amlogic: SD card support for all Tronsmart Vega S95
>>     devices
>>   ARM64: dts: amlogic: eMMC support for all Tronsmart Vega S95 devices
>>   ARM64: dts: amlogic: enable ethernet on all Tronsmart Vega S95 devices
>
> I've applied the ethernet one, but I'm going to wait on the SD/eMMC
> patches until the driver is finalized for the other one.

Oops, I replied on the wrong thread, but just to be clear, I applied
v2 of the ethernet patch, though it doesn't make too much difference
in this case.

Kevin