[LEDE-DEV] [PATCH v2] ramips: add support for Ubiquiti EdgeRouter X-SFP

[Torbjorn Jansson]

On 2017-05-29 11:24, Sven Roederer wrote:
> This patch adds support for the Ubiquiti EdgeRouter X-SFP and
> improves support for the EdgeRouter X (PoE-passthrough).
> 
> Specification:
> - SoC: MediaTek MT7621AT
> - Flash: 256 MiB
> - RAM: 265 MiB
> - Ethernet: 5 x LAN (1000 Mbps)
> - UART: 1 x UART on PCB (3.3V, RX, TX, GND) - 57600 8N1
> - EdgeRouter X:
>    - 1 x PoE-Passtrough (Eth4)
>    - powered by Wallwart or passive PoE
> - EdgeRouter X-SFP:
>    - 5 x PoE-Out (24V, passive)
>    - 1 x SFP (unknown status)
>    - powered by Wallwart (24V)


regarding the sfp port, it does not show up on the luci switch page.
this port seems to be missing.

what i have is CPU (eth0) and then lan 1 to 4 and a WAN

WAN is the port labeled eth0 on the device and then lan 1-4 must be eth1-4
sfp port is labeled eth5 and as far as i can tell doesn't work.

is this just a minor config issue so this port is perhaps not configured 
at all with vlan and so on?