[LEDE-DEV] [PATCH 1/2 v2] ipq806x/nbg6817: fixup internal mmc and switch configuration in DTS

[André Valentin]

The setting mmc-ddr-1_8v in the platform dts leads to read errors. The
device is unusable and system reboots in a loop. Because NBG6817 is the
only mmc device, I removed it in base dts.

The second change removes settings now present in base dts.

The third change references was a wrong conversion of constants in the switch settings.
Switch now initializes again.

Signed-off-by: André Valentin <avalentin at marcant.net>
---
 target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065-nbg6817.dts | 4 +---
 target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065.dtsi        | 2 +-
 2 files changed, 2 insertions(+), 4 deletions(-)

diff --git a/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065-nbg6817.dts b/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065-nbg6817.dts
index abc381a..4db1a30 100644
--- a/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065-nbg6817.dts
+++ b/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065-nbg6817.dts
@@ -234,7 +234,7 @@
 			compatible = "virtual,mdio-gpio";
 			#address-cells = <1>;
 			#size-cells = <0>;
-			gpios = <&qcom_pinmux 1 GPIO_ACTIVE_LOW &qcom_pinmux 0 GPIO_ACTIVE_LOW>;
+			gpios = <&qcom_pinmux 1 GPIO_ACTIVE_HIGH &qcom_pinmux 0 GPIO_ACTIVE_HIGH>;
 			pinctrl-0 = <&mdio0_pins>;
 			pinctrl-names = "default";
 
@@ -323,8 +323,6 @@
 		amba {
 			sdcc1: sdcc at 12400000 {
 				status = "okay";
-				dmas = <&sdcc1bam 2>, <&sdcc1bam 1>;
-				dma-names = "tx", "rx";
 			};
 		};
 	};
diff --git a/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065.dtsi b/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065.dtsi
index 8721577..411ffc3 100644
--- a/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065.dtsi
+++ b/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8065.dtsi
@@ -123,7 +123,6 @@
 				non-removable;
 				cap-sd-highspeed;
 				cap-mmc-highspeed;
-				mmc-ddr-1_8v;
 				vmmc-supply = <&vsdcc_fixed>;
 				dmas = <&sdcc1bam 2>, <&sdcc1bam 1>;
 				dma-names = "tx", "rx";
-- 
2.1.4