[LEDE-DEV] Fwd: TP-Link Archer C7 boot loop

Jon jhpike at cox.net
Wed Oct 19 00:57:54 PDT 2016


  Hello all,  am having a similar problem with a boot loop.  After an 
attempted flash of a LEDE build,  my router is in a 5-6 second loop.

Am 20.08.2016 um 23:35 schrieb Jochen Demmer:
>
> > yesterday I bricked an Archer C7 v2 by installing some homebrew 
> (buildroot) lede firmware. > It got stuck in a boot loop and it's also 
> not reachable on 192.168.1.1 on any time during > boot whatsoever. No 
> failsafe mode. Archer C7 v2 can be un-brick with TFTP and U-Boot of 
> the router. If you try it with the serial console, you need a program 
> which hits 'tpl' for you. > I don't know how to debug this. Could 
> someone give me a hint? Is maybe something wrong > within lede for 
> Archer C7 ? Did you connect a UART adapter to the router? My Lede 
> build for Archer C7 v2 works perfectly. I did never use the 
> pre-compiled images and I'm using sysupgrade images only. Regards, Hartmut
  I've progressed thru successful serial terminal configuration, and am 
observing the loop,  as well as the TFTP firmware loads attemps.
I seem to be failing a check of product ID and version.  Then, the 
router attempts to boot the firmware with the same failure that I see in 
the regular boot loop:

> #Example of firmware TFTP load,  and subsequent problem leading to reboot
>
> dup 1 speed 1000
> Using eth1 device
> TFTP from server 192.168.0.66; our IP address is 192.168.0.86
> Filename 'ArcherC7v2_tp_recovery.bin'.
> Load address: 0x80060000
> Loading: T 
> #################################################################
>          #######################
editing out hashtags
> #################################################################
> #################################################################
>          #######################################################
> done
> Bytes transferred = 16252928 (f80000 hex)
> original_product_id = ffffffff
>  original_product_ver = ffffffff
>  recovery_product_id = c7000002
>  recovery_product_ver = 01
>  auto update firmware: product id verify fail!
> Autobooting in 1 seconds
> ## Booting image at 9f020000 ...
>    Uncompressing Kernel Image ... Stream with EOS marker is not 
> supportedLZMA ERROR    1 - must RESET board to recover
>
> U-Boot 1.1.4 (Oct 14 2015 - 13:34:14)

The last part starting at the "Autobooting in 1 seconds",  is the end of 
the boot loop,  where it complains,  then U-Boot starts again. The 
regular loop is much longer,  culminating in the image boot and the same 
error.

My problem is,  I can't seem to catch it with tpl,   to stop it and get 
to console.   Have seen another method of erasing and writing from the 
console, but either I need to type faster,  or something's wrong with my 
console config.  Are there any other ways to stop a boot and go to console?

Thanks...

Jon



More information about the Lede-dev mailing list