[LEDE-DEV] Fwd: WPJ344 libphy not finding AR8337 for eth0.

[Nick Dennis]

Hi,
I have been using openWRT CC 1505, but want to start using LEDE. I built 
for the WPJ344, but didn't get pings to or from my PC.
I have a serial connection to the wpj344, so i can look at demsg without 
an eth connection.
For CC, the relevent lines are (some spacing added):
...
[    0.850000] 0x000000ff0000-0x000001000000 : "art"
[    0.870000] libphy: ag71xx_mdio: probed
[    0.870000] switch0: Atheros AR8337 rev. 2 switch registered on 
ag71xx-mdio.0
[    0.940000] libphy: ag71xx_mdio: probed
[    1.540000] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.0:00 
[uid=004dd036, driver=Atheros AR8216/AR8236/AR8316]

[    1.550000] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:RGMII
[    2.140000] ag71xx-mdio.1: Found an AR934X built-in switch
[    2.180000] eth1: Atheros AG71xx at 0xba000000, irq 5, mode:GMII
[    2.190000] TCP: cubic registered
...
For LEDE:
...
[    0.904631] 0x000000ff0000-0x000001000000 : "art"
[    0.925684] libphy: ag71xx_mdio: probed

[    0.933207] libphy: ag71xx_mdio: probed
[    1.522084] ag71xx ag71xx.0: no PHY found with phy_mask=00000001


[    2.112580] ag71xx-mdio.1: Found an AR934X built-in switch
[    2.154948] eth0: Atheros AG71xx at 0xba000000, irq 5, mode:GMII
[    2.163279] NET: Registered protocol family 10
...

I'll continue investigating, but has anyone else run across this? Maybe 
fixed it?

Thanks