[openwrt/openwrt] mediatek: update openembed som7981 support
LEDE Commits
lede-commits at lists.infradead.org
Thu Dec 26 05:16:23 PST 2024
hauke pushed a commit to openwrt/openwrt.git, branch openwrt-24.10:
https://git.openwrt.org/d9bbed6507c9126bb8977b6e224186a624282ba0
commit d9bbed6507c9126bb8977b6e224186a624282ba0
Author: Tianling Shen <cnsztl at immortalwrt.org>
AuthorDate: Wed Oct 16 16:05:40 2024 +0800
mediatek: update openembed som7981 support
The board has been redesigned due to previous hardware bugs
(with other reasons maybe).
Changes in new board:
- Added a gpio beeper
- Added a Atmel i2c eeprom
- Added a Atmel i2c ECC accelerator
- Added a Philips RTC module
- Added two RS485
- Removed WPS button
- Replaced USB3 port with M.2 B-key for LTE modules
- Swapped GbE LEDs gpio
Also assigned wifi mac with nvmem binding, added iface setup for failsafe,
increased phy assert time for rtl8221b, and updated LED labels.
Keeping compatibility for old version is not necessary here as only
few samples were sent to those interested in it.
Signed-off-by: Tianling Shen <cnsztl at immortalwrt.org>
Link: https://github.com/openwrt/openwrt/pull/17253
(cherry picked from commit 5a7fb834c7cb53cac7855759ca4165f596f1e4c8)
Link: https://github.com/openwrt/openwrt/pull/17348
Signed-off-by: Hauke Mehrtens <hauke at hauke-m.de>
---
.../base-files/lib/preinit/05_set_preinit_iface | 3 +-
.../mediatek/dts/mt7981b-openembed-som7981.dts | 111 +++++++++++++++++----
.../filogic/base-files/etc/board.d/01_leds | 4 +-
.../etc/hotplug.d/ieee80211/11_fix_wifi_mac | 3 -
target/linux/mediatek/image/filogic.mk | 5 +-
5 files changed, 99 insertions(+), 27 deletions(-)
diff --git a/target/linux/mediatek/base-files/lib/preinit/05_set_preinit_iface b/target/linux/mediatek/base-files/lib/preinit/05_set_preinit_iface
index 0deab42481..1025d1f1e1 100644
--- a/target/linux/mediatek/base-files/lib/preinit/05_set_preinit_iface
+++ b/target/linux/mediatek/base-files/lib/preinit/05_set_preinit_iface
@@ -2,7 +2,8 @@ set_preinit_iface() {
case $(board_name) in
cudy,m3000-v1|\
cudy,tr3000-v1|\
- glinet,gl-mt3000)
+ glinet,gl-mt3000|\
+ openembed,som7981)
ip link set eth1 up
ifname=eth1
;;
diff --git a/target/linux/mediatek/dts/mt7981b-openembed-som7981.dts b/target/linux/mediatek/dts/mt7981b-openembed-som7981.dts
index 0e9dea1ddb..d5c868567b 100644
--- a/target/linux/mediatek/dts/mt7981b-openembed-som7981.dts
+++ b/target/linux/mediatek/dts/mt7981b-openembed-som7981.dts
@@ -12,9 +12,10 @@
compatible = "openembed,som7981", "mediatek,mt7981";
aliases {
- led-boot = &wlan2g_led;
- led-failsafe = &wlan2g_led;
- led-upgrade = &wlan2g_led;
+ led-boot = &act_led;
+ led-failsafe = &act_led;
+ led-running = &act_led;
+ led-upgrade = &act_led;
serial0 = &uart0;
};
@@ -26,6 +27,11 @@
reg = <0 0x40000000 0 0x40000000>;
};
+ beeper {
+ compatible = "gpio-beeper";
+ gpios = <&pio 2 GPIO_ACTIVE_HIGH>;
+ };
+
gpio-keys {
compatible = "gpio-keys";
@@ -34,12 +40,6 @@
linux,code = <KEY_RESTART>;
gpios = <&pio 1 GPIO_ACTIVE_LOW>;
};
-
- button-wps {
- label = "wps";
- linux,code = <KEY_WPS_BUTTON>;
- gpios = <&pio 0 GPIO_ACTIVE_LOW>;
- };
};
gpio-leds {
@@ -47,28 +47,27 @@
led-0 {
function = LED_FUNCTION_LAN;
- color = <LED_COLOR_ID_AMBER>;
+ color = <LED_COLOR_ID_GREEN>;
gpios = <&pio 8 GPIO_ACTIVE_LOW>;
};
led-1 {
function = LED_FUNCTION_LAN;
- color = <LED_COLOR_ID_GREEN>;
+ color = <LED_COLOR_ID_AMBER>;
gpios = <&pio 13 GPIO_ACTIVE_LOW>;
};
- wlan2g_led: led-2 {
- function = LED_FUNCTION_WLAN_2GHZ;
- color = <LED_COLOR_ID_RED>;
+ led-2 {
+ function = LED_FUNCTION_PANIC;
+ color = <LED_COLOR_ID_GREEN>;
gpios = <&pio 34 GPIO_ACTIVE_LOW>;
- linux,default-trigger = "phy0tpt";
+ panic-indicator;
};
- led-3 {
- function = LED_FUNCTION_WLAN_5GHZ;
+ act_led: led-3 {
+ function = LED_FUNCTION_ACTIVITY;
color = <LED_COLOR_ID_RED>;
gpios = <&pio 35 GPIO_ACTIVE_LOW>;
- linux,default-trigger = "phy1tpt";
};
};
};
@@ -97,14 +96,38 @@
};
};
+&i2c0 {
+ clock-frequency = <400000>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2c0_pins>;
+ status = "okay";
+
+ eeprom at 50 {
+ compatible = "atmel,24c64";
+ reg = <0x50>;
+ page-size = <32>;
+ };
+
+ rtc at 51 {
+ compatible = "nxp,pcf8563";
+ reg = <0x51>;
+ #clock-cells = <0>;
+ };
+
+ crypto at 60 {
+ compatible = "atmel,atecc508a";
+ reg = <0x60>;
+ };
+};
+
&mdio_bus {
phy0: ethernet-phy at 5 {
reg = <5>;
compatible = "ethernet-phy-ieee802.3-c45";
phy-mode = "2500base-x";
reset-gpios = <&pio 14 GPIO_ACTIVE_LOW>;
- reset-assert-us = <10000>;
- reset-deassert-us = <50000>;
+ reset-assert-us = <15000>;
+ reset-deassert-us = <68000>;
realtek,aldps-enable;
};
};
@@ -184,6 +207,13 @@
};
&pio {
+ i2c0_pins: i2c0-pins {
+ mux {
+ function = "i2c";
+ groups = "i2c0_1";
+ };
+ };
+
spi0_flash_pins: spi0-pins {
mux {
function = "spi";
@@ -202,12 +232,45 @@
mediatek,pull-down-adv = <0>;
};
};
+
+ uart1_pins: uart1-pins {
+ mux {
+ function = "uart";
+ groups = "uart1_3";
+ };
+ };
+
+ uart2_pins: uart2-pins {
+ mux {
+ function = "uart";
+ groups = "uart2_0_tx_rx";
+ };
+ };
+
+ wwan_rst_h: wwan-rst-h {
+ pins = "GPIO_WPS";
+ drive-strength = <8>;
+ mediatek,pull-down-adv = <0>;
+ output-low;
+ };
};
&uart0 {
status = "okay";
};
+&uart1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart1_pins>;
+ status = "okay";
+};
+
+&uart2 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart2_pins>;
+ status = "okay";
+};
+
&usb_phy {
status = "okay";
};
@@ -220,8 +283,16 @@
nvmem-cells = <&eeprom_factory_0>;
nvmem-cell-names = "eeprom";
status = "okay";
+
+ band at 1 {
+ reg = <1>;
+ nvmem-cells = <&macaddr_factory_a 0>;
+ nvmem-cell-names = "mac-address";
+ };
};
&xhci {
+ pinctrl-names = "default";
+ pinctrl-0 = <&wwan_rst_h>;
status = "okay";
};
diff --git a/target/linux/mediatek/filogic/base-files/etc/board.d/01_leds b/target/linux/mediatek/filogic/base-files/etc/board.d/01_leds
index 64df50eb0a..168909cf90 100644
--- a/target/linux/mediatek/filogic/base-files/etc/board.d/01_leds
+++ b/target/linux/mediatek/filogic/base-files/etc/board.d/01_leds
@@ -67,8 +67,8 @@ nokia,ea0326gmp)
ucidef_set_led_netdev "wlan" "WLAN" "green:wlan" "phy1-ap0" "link"
;;
openembed,som7981)
- ucidef_set_led_netdev "lanact" "LANACT" "green:lan" "eth1" "rx tx"
- ucidef_set_led_netdev "lanlink" "LANLINK" "amber:lan" "eth1" "link"
+ ucidef_set_led_netdev "lanact" "LANACT" "amber:lan" "eth1" "rx tx"
+ ucidef_set_led_netdev "lanlink" "LANLINK" "green:lan" "eth1" "link"
;;
openwrt,one)
ucidef_set_led_netdev "wanact" "WANACT" "mdio-bus:0f:green:wan" "eth0" "rx tx"
diff --git a/target/linux/mediatek/filogic/base-files/etc/hotplug.d/ieee80211/11_fix_wifi_mac b/target/linux/mediatek/filogic/base-files/etc/hotplug.d/ieee80211/11_fix_wifi_mac
index 5e83a167de..4a6e0589a2 100644
--- a/target/linux/mediatek/filogic/base-files/etc/hotplug.d/ieee80211/11_fix_wifi_mac
+++ b/target/linux/mediatek/filogic/base-files/etc/hotplug.d/ieee80211/11_fix_wifi_mac
@@ -131,9 +131,6 @@ case "$board" in
[ "$PHYNBR" = "0" ] && macaddr_add $addr 1 > /sys${DEVPATH}/macaddress
[ "$PHYNBR" = "1" ] && macaddr_add $addr 2 > /sys${DEVPATH}/macaddress
;;
- openembed,som7981)
- [ "$PHYNBR" = "1" ] && cat /sys/class/net/eth0/address > /sys${DEVPATH}/macaddress
- ;;
qihoo,360t7)
addr=$(mtd_get_mac_ascii factory lanMac)
[ "$PHYNBR" = "0" ] && macaddr_add $addr 2 > /sys${DEVPATH}/macaddress
diff --git a/target/linux/mediatek/image/filogic.mk b/target/linux/mediatek/image/filogic.mk
index 7b356ec03d..dd1ee5493d 100644
--- a/target/linux/mediatek/image/filogic.mk
+++ b/target/linux/mediatek/image/filogic.mk
@@ -1160,7 +1160,10 @@ define Device/openembed_som7981
DEVICE_MODEL := SOM7981
DEVICE_DTS := mt7981b-openembed-som7981
DEVICE_DTS_DIR := ../dts
- DEVICE_PACKAGES := kmod-mt7915e kmod-mt7981-firmware mt7981-wo-firmware kmod-usb3
+ DEVICE_PACKAGES := kmod-mt7915e kmod-mt7981-firmware mt7981-wo-firmware \
+ kmod-crypto-hw-atmel kmod-eeprom-at24 kmod-gpio-beeper kmod-rtc-pcf8563 \
+ kmod-usb-net-cdc-mbim kmod-usb-net-qmi-wwan kmod-usb-serial-option \
+ kmod-usb3 uqmi
UBINIZE_OPTS := -E 5
BLOCKSIZE := 128k
PAGESIZE := 2048
More information about the lede-commits
mailing list