[openwrt/openwrt] sunxi: enable wifi module on Pine64 boards
LEDE Commits
lede-commits at lists.infradead.org
Mon Mar 29 21:09:24 BST 2021
wigyori pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/bb9915407bdf24fd45daa49b32715fe3e8e00be0
commit bb9915407bdf24fd45daa49b32715fe3e8e00be0
Author: Zoltan HERPAI <wigyori at uid0.hu>
AuthorDate: Sun Feb 28 16:42:05 2021 +0100
sunxi: enable wifi module on Pine64 boards
The Pine64(+) and the SoPine64 baseboard has an optional BT+WiFi
module, carrying an RTL8723BS. The wifi part is connected via
SDIO, the BT part is connected via UART. The BT part requires
additional code changes in the drivers so we'll skip that until 5.10.
Aside from a DTS patch to enable the wifi module, add the required
packages into the device definitions.
[ 8.996970] RTL8723BS: module init start
[ 9.000922] RTL8723BS: rtl8723bs v4.3.5.5_12290.20140916_BTCOEX20140507-4E40
[ 9.007965] RTL8723BS: rtl8723bs BT-Coex version = BTCOEX20140507-4E40
[ 9.014785] pnetdev = 000000009bdd5000
[ 9.047780] RTL8723BS: rtw_ndev_init(wlan0)
[ 9.053349] RTL8723BS: module init ret =0
root at OpenWrt:/# iw list
Wiphy phy0
wiphy index: 0
max # scan SSIDs: 9
max scan IEs length: 2304 bytes
max # sched scan SSIDs: 0
max # match sets: 0
Retry short limit: 7
Retry long limit: 4
Coverage class: 0 (up to 0m)
Available Antennas: TX 0 RX 0
Supported interface modes:
* IBSS
* managed
* AP
* monitor
Band 1:
Frequencies:
* 2412 MHz [1] (20.0 dBm)
* 2417 MHz [2] (20.0 dBm)
* 2422 MHz [3] (20.0 dBm)
* 2427 MHz [4] (20.0 dBm)
* 2432 MHz [5] (20.0 dBm)
* 2437 MHz [6] (20.0 dBm)
* 2442 MHz [7] (20.0 dBm)
* 2447 MHz [8] (20.0 dBm)
* 2452 MHz [9] (20.0 dBm)
* 2457 MHz [10] (20.0 dBm)
* 2462 MHz [11] (20.0 dBm)
* 2467 MHz [12] (20.0 dBm) (no IR)
* 2472 MHz [13] (20.0 dBm) (no IR)
* 2484 MHz [14] (20.0 dBm) (no IR)
Signed-off-by: Zoltan HERPAI <wigyori at uid0.hu>
---
target/linux/sunxi/image/cortexa53.mk | 2 +
...50-arm64-dts-enable-wifi-on-pine64-boards.patch | 72 ++++++++++++++++++++++
2 files changed, 74 insertions(+)
diff --git a/target/linux/sunxi/image/cortexa53.mk b/target/linux/sunxi/image/cortexa53.mk
index 117d25ea90..fe561d0923 100644
--- a/target/linux/sunxi/image/cortexa53.mk
+++ b/target/linux/sunxi/image/cortexa53.mk
@@ -66,6 +66,7 @@ TARGET_DEVICES += olimex_a64-olinuxino-emmc
define Device/pine64_pine64-plus
DEVICE_VENDOR := Pine64
DEVICE_MODEL := Pine64+
+ DEVICE_PACKAGES := kmod-rtl8723bs rtl8723bs-firmware
$(Device/sun50i-a64)
endef
TARGET_DEVICES += pine64_pine64-plus
@@ -73,6 +74,7 @@ TARGET_DEVICES += pine64_pine64-plus
define Device/pine64_sopine-baseboard
DEVICE_VENDOR := Pine64
DEVICE_MODEL := SoPine
+ DEVICE_PACKAGES := kmod-rtl8723bs rtl8723bs-firmware
$(Device/sun50i-a64)
endef
TARGET_DEVICES += pine64_sopine-baseboard
diff --git a/target/linux/sunxi/patches-5.4/450-arm64-dts-enable-wifi-on-pine64-boards.patch b/target/linux/sunxi/patches-5.4/450-arm64-dts-enable-wifi-on-pine64-boards.patch
new file mode 100644
index 0000000000..8117338029
--- /dev/null
+++ b/target/linux/sunxi/patches-5.4/450-arm64-dts-enable-wifi-on-pine64-boards.patch
@@ -0,0 +1,72 @@
+--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
++++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
+@@ -78,6 +78,11 @@
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ };
++
++ wifi_pwrseq: wifi_pwrseq {
++ compatible = "mmc-pwrseq-simple";
++ reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* PL2 */
++ };
+ };
+
+ &ac_power_supply {
+@@ -138,6 +143,21 @@
+ reg = <1>;
+ };
+ };
++
++&mmc1 {
++ pinctrl-names = "default";
++ pinctrl-0 = <&mmc1_pins>;
++ vmmc-supply = <®_dldo4>;
++ vqmmc-supply = <®_eldo1>;
++ mmc-pwrseq = <&wifi_pwrseq>;
++ bus-width = <4>;
++ non-removable;
++ status = "okay";
++
++ rtl8723cs: wifi at 1 {
++ reg = <1>;
++ };
++};
+
+ &mmc2 {
+ pinctrl-names = "default";
+--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-pine64.dts
++++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-pine64.dts
+@@ -73,6 +73,11 @@
+ };
+ };
+ };
++
++ wifi_pwrseq: wifi_pwrseq {
++ compatible = "mmc-pwrseq-simple";
++ reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* PL2 */
++ };
+ };
+
+ &codec {
+@@ -146,6 +151,21 @@
+ status = "okay";
+ };
+
++&mmc1 {
++ pinctrl-names = "default";
++ pinctrl-0 = <&mmc1_pins>;
++ vmmc-supply = <®_dldo4>;
++ vqmmc-supply = <®_eldo1>;
++ mmc-pwrseq = <&wifi_pwrseq>;
++ bus-width = <4>;
++ non-removable;
++ status = "okay";
++
++ rtl8723cs: wifi at 1 {
++ reg = <1>;
++ };
++};
++
+ &ohci0 {
+ status = "okay";
+ };
More information about the lede-commits
mailing list