[openwrt/openwrt] x86: add Roqos Core RC10 ethernet interfaces

[LEDE Commits]

hauke pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/09448d8ff30d7c1474c8dd0a762efe0417c471bd

commit 09448d8ff30d7c1474c8dd0a762efe0417c471bd
Author: Tomasz Maciej Nowak <tmn505 at gmail.com>
AuthorDate: Mon May 24 14:41:15 2021 +0200

    x86: add Roqos Core RC10 ethernet interfaces
    
    eth0 -> single NIC (i211at)
    eth1 -> single NIC (i211at) -> 4-port unmanaged switch (BCM53125U)
    
    Notes
    UART is exposed on J4 connector, pinout starting from pin marked 1:
    1. GND, 2. NC?, 3. NC?, 4. RX, 5. TX, 6. NC?
    baud: 115200, parity: none, flow control: none
    The board is setup by coreboot with UEFI. To enter setup screen hold
    ESC key on boot.
    The 5-LED multicolor matrix is attached on first I2C device named
    "Synopsys DesignWare I2C adapter" at address 0x60. Controlling values
    are stored in /opt/roqos/etc/rcLED.conf of original firmware.
    Remember to backup the original firmware, there are no downloadable
    copies.
    
    Signed-off-by: Tomasz Maciej Nowak <tmn505 at gmail.com>
---
 target/linux/x86/base-files/etc/board.d/02_network | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/target/linux/x86/base-files/etc/board.d/02_network b/target/linux/x86/base-files/etc/board.d/02_network
index 581daf49b6..30035dcbe9 100644
--- a/target/linux/x86/base-files/etc/board.d/02_network
+++ b/target/linux/x86/base-files/etc/board.d/02_network
@@ -11,6 +11,9 @@ case "$(board_name)" in
 pc-engines-apu1|pc-engines-apu2|pc-engines-apu3)
 	ucidef_set_interfaces_lan_wan "eth1 eth2" "eth0"
 	;;
+roqos-roqos-core-rc10)
+	ucidef_set_interfaces_lan_wan "eth1" "eth0"
+	;;
 sophos-sg-105|sophos-xg-105)
 	ucidef_set_interfaces_lan_wan "eth0 eth2 eth3" "eth1"
 	;;